[Illustration: FIG. 55.—UPSETTING FOR A SQUARE CORNER.]
Heat and bend the stock at the upset center to a right angle, with the upset metal on the outer side to provide for the square corner. The bending should be done over the horn of the anvil to produce the quarter-round fillet on the inner side, and may be confined to the center by cooling both ends to where the upsetting begins.
As bends of this kind are somewhat difficult to make correctly, it would be a great advantage to provide a form which may be made to fit into the vise; then one end of the angle can be held securely with the form while the opposite end is bent over it. By any simple form it is impossible to make the outside corner perfectly sharp and square with one operation; it is therefore necessary to forge the outside corner sharp and square by delivering blows on both sides, somewhat in the manner shown in Fig. 56, but good judgment must be used in doing this.
[Illustration: FIG. 56.—SQUARE-CORNERED ANGLE.]
The chamfering may be marred or entirely removed in forging the corner; if so, rechamfer, and if the ends are of unequal lengths, the longer one should be cut off equal with the other. Then all surfaces should be made straight and smooth with the flatter and the scale removed by occasionally dipping the flatter in water.
=76. Fagot Welding.=—Welding and forging to dimensions. Material required: convenient pieces of scrap iron and a bar of 5/8-inch round stock from 24 to 30 inches long.
Temporarily weld several separate pieces of scrap on to the bar until sufficient metal is provided for a thorough welding and forging of a solid piece of square iron 3-1/2 inches long and 11/16 inch square. The welding should be done so as not to show where the pieces were joined. Forge it perfectly square and smooth with the flatter. Cut one end off square with a sharp hot cutter, then cut it to the required length.
=77. Round Weld.=—Fig. 57. Scarfing, welding, and swaging. Material required: two pieces of 7/16-inch round iron, 4-1/2 inches long.
Upset one end to 9/16 inch, as shown at _a_. To form the scarf, deliver backing-up blows with the face of the hammer, as shown at _b_, and finish with blows delivered similarly with the ball. These backing-up blows will form the heel of the scarf. Draw out the point of the scarf with overhanging blows, as shown at _c_. The joining surface should be convex so that welding will proceed from the center. Scarf both pieces in the same manner, as at _d_.