The Rolls-Royce Olympus turbojet engine was developed extensively throughout its production run, the many variants can be described as belonging to four main groups.
Initial non-afterburning variants were designed and produced by Bristol Aero Engines and Bristol Siddeley (BSEL) and powered the Avro Vulcan. These engines were further developed by Rolls-Royce Limited.
The first afterburning variant, the Bristol Siddeley Olympus Mk 320, powered the cancelled BAC TSR-2 strike aircraft. A further afterburning variant was the Rolls-Royce/Snecma Olympus 593, jointly developed to power Concorde in the 1960s.
The American Curtiss-Wright company tested a license-developed version known as the J67 and a turboprop designated TJ-38 Zephyr. Neither design was produced.
Further derivatives of the Olympus were produced for ship propulsion and land-based power generation.
Bristol Aero Engines, Bristol Siddeley and Rolls-Royce variants
Company designations
BOl.1/2A
BOl.1/2B
BOl.1/2C
BOl.2
BOl.3 Of all the early initial developments, BOl.2 to BOl.5 (the BOl.5 was never built), perhaps the most significant was the BOl.3. Even before the Vulcan first flew, the Olympus 3 was being suggested as the definitive powerplant for the aircraft. In the event, the 'original' Olympus was continuously developed for the Vulcan B1. The BOl.3 was described in 1957 as "a high-ended product intermediate between the Olympus 100 and 200 series."
BOl.4
BOl.5not built
BOl.6(Mk.200) The initial design of the second-generation 'Olympus 6' began in 1952. This was a major redesign with five LP and seven HP compressor stages and a cannular combustor with eight interconnected flame tubes. In spite of a much greater mass flow, the size and weight of the BOl.6 was little different from earlier models. thrust. Used for first B2 Vulcan (XH533) only.
Rival manufacturers Rolls-Royce lobbied very hard to have its Conway engine installed in the Vulcan B2 to achieve commonality with the Victor B2. As a consequence, Bristol undertook to complete development using company funds and peg the price to that of its fully government-funded rival.
BOl.7(Mk.201)
BOl.7SR
BOl.11(Mk.102)
BOl.12(Mk.104)
BOl.21(Mk.301)
BOl.21R not built, proposed for R.A.E. Missile (A) designed to meet O.R. 1149 issued May 1956.
BOl.22R(Mk.320)
BOl.23 not built, proposed with a 301 compressor, 22R turbine and reheat to give at take-off (reheat).
Service designations
Olympus Mk 97 This early engine tested an early annular combustion chamber. It was test flown on Bristol's Avro Ashton test bed WB493.
Olympus Mk 100 (BOl.1/2B) Similar to Olympus Mk 99 rated at thrust for second Vulcan prototype VX777. First flew September 1953.
Olympus Mk 101 (BOl.1/2C) Larger turbine, thrust for initial production Vulcan B1 aircraft. First flew (XA889) February 1955.
Olympus Mk 102 (BOl.11) Additional zero stage on LP compressor, thrust for later production Vulcan B1 aircraft.
Olympus Mk 104 (BOl.12) Designation for Olympus Mk 102 modified on overhaul with new turbine and burners, thrust initially, thrust on uprating, standard on Vulcan B1A. 'Olympus 106' Used to describe the development engine for the Olympus 200 (BOl.6). Possibly a corruption of BOl.6 (Olympus 6).
Olympus Mk 201 (BOl.7) Uprated Olympus Mk 200. thrust. Initial Vulcan B2 aircraft.
Olympus Mk 202 Disputed. Either Olympus Mk 201 modified with rapid air starter, or Olympus Mk 201 with redesigned oil separator breathing system. This was the definitive '200 series' engine fitted to Vulcans not fitted with the Mk 301. The restored Vulcan XH558 is fitted with Olympus Mk 202 engines.
'Olympus Mk 203' Very occasional reference to this elusive mark of engine can be found in some official Air Publications relating to the Vulcan B2. It is also noted in a manufacturer's archived document dated circa 1960.
Olympus Mk 301 (BOl.21) Additional zero stage on LP compressor. thrust. Later Vulcan B2 aircraft plus nine earlier aircraft retrofitted. Later derated to thrust. Restored to original rating for Operation Black Buck.
Olympus 510 series With a thrust in the region of , the 510 series were civilianised versions of the BOl.6. A team was sent to Boeing at Seattle to promote the engine in 1956 but without success.