For this purpose, we often use a small black ebony rule, (see Fig. 4. Plate II. A,) three or four tenths of an inch broad, and about seven inches long; at each inch is fixed a piece of ivory, the first inch is entirely of ivory, and subdivided into ten equal parts.
2. A piece of glass, Fig. 2, fixed in a brass or ivory slider; on the diameter of this are drawn two parallel lines, about three-tenths of an inch long; each tenth being divided, one into three, the second into four, the third into five parts. To use this, place the glass, Fig. 2, on the middle of the stage, and the rule, Fig. 4, on one side, but parallel to it; then look into the microscope with one eye, keeping the other open, and observe how many parts one-tenth of a line in the microscope takes in upon the parts of the rule seen by the naked eye. For instance, suppose with a fourth magnifier that one-tenth of an inch magnified answers in length to forty-tenths or parts on the rule, when seen by the naked eye, then this magnifier increases the diameter of the object forty times.
This mode of actual admeasurement is, without doubt, the most simple that can be used; by it we comprehend, as it were, at one glance, the different effects of combined glasses; it saves the trouble, and avoids the obscurity that attends the usual modes of calculation; but many persons find it exceedingly difficult to adopt this method, because they have not been accustomed to observe with both eyes at once. We shall therefore proceed to describe another method, which has not this inconvenience.
Fig. 8. Plate II. A, represents this micrometer. The first of this kind was made by my father, and was described by him in his Micrographia Illustrata. It consists of a screw, which has fifty threads to an inch; this screw carries an index, which points to the divisions on a circular plate, which is fixed at right angles to the axis of the screw. The revolutions of the screw are counted on a scale, which is an inch divided into fifty parts; the index to these divisions is a flower de luce marked upon the slider, which carries the needle point across the field of the microscope. Every revolution of the micrometer screw measures ¹⁄₅₀ part of an inch, which is again subdivided by means of the divisions on the circular plate, as this is divided into twenty equal parts, over which the index passes at every revolution of the screw; by which means, we obtain with ease the measure of one-thousandth part of an inch; for 50, the number of threads on the screw in one inch, being multiplied by 20, the divisions on the circular plate, are equal to 1000; so that each division on the circular plate shews that the needle has either advanced or receded one-thousandth part of an inch.