Figs. 382 and 383 represent two forms of hook bolt for use in cases where it is not desired to have bolt holes through both pieces of the work. In Fig. 382 the head projects under the work and for some distance beneath and beyond the washer, as is denoted by the dotted line, hence it would suspend piece A from B or piece B from A. But in Fig. 383 the nut pressure is not beneath the part where the hook D grips the work, hence the nut would exert a pressure to pull piece B in the direction of the arrow; hence if B were a fixed piece the bolt would suspend A from it, but it could not suspend B from A.
In woodwork the pressure of the nut is apt to compress the wood, causing the bolt head and nut to sink into the wood, and to obviate this, anchor plates are used to increase the area receiving the pressure; thus in Fig. 384 a plate is tapped to serve instead of a nut, and a similar plate may of course be placed under the bolt head.
The Franklin Institute or United States Standard for the dimensions of bolt heads and nuts is as follows. In Fig. 385, D represents the diameter of the bolt, J represents the short diameter or width across flats of the bolt head or of the nut, being equal to one and a half times the diameter of the bolt, plus 1/16 inch for finished heads or nuts, and plus 1/8 inch for rough or unfinished heads or nuts. K represents the depth or thickness of the head or nut, which in finished heads or nuts equals the diameter of the bolt minus 1/16 inch, and in rough heads equals one half the distance between the parallel sides of the head, or in other words one half the width across the flats of the head.
H represents the thickness or depth of the nut, which for finished nuts is made equal to the diameter of the bolt less 1/16 inch, and therefore the same thickness as the finished bolt head, while for rough or unfinished nuts it is made equal to the diameter of the bolt or the same as the rough bolt head. I represents the long diameter or diameter across corners, which, however, is a dimension not used to work to, and is inserted in the following tables merely for reference:--
TABLE OF THE FRANKLIN INSTITUTE STANDARD DIMENSIONS FOR THE HEADS OF BOLTS AND FOR THEIR NUTS, WHEN BOTH HEADS AND NUTS ARE OF HEXAGON FORM, AND ARE POLISHED OR FINISHED.