Coke is essentially a partially graphitized carbon, its density being about midway between that of coal and graphite, and it should therefore occupy less space than the original coal; but owing to the softening of the charge a spongy structure is set up by the escaping gases, which acts in the other direction, so that for equal bulk coke is somewhat lighter than coal. It is this combination of properties that gives it its chief value in iron smelting, the substance being sufficiently dense to resist oxidation by carbon dioxide in the higher regions of the furnace, while the vesicular structure gives an extended surface for the action of heated air and facilitates rapid consumption at the tuyeres. Compact coke, such as that formed on the inner sides of gas retorts (retort carbon), can only be burned with great difficulty in small furnaces of special construction, but it gives out a great amount of heat.
The most deleterious constituents of coke are ash, sulphur and volatile constituents including water. As the coke yield is only from two-thirds to three-quarters of that of the coal, the original proportion of ash is augmented by one-third or one-half in the product. For this reason it is now customary to crush and wash the coal carefully to remove intermingled patches of shale and dirt before coking, so that the ash may not if possible exceed 10% in the coke. About one-half of the sulphur in the coal is eliminated in coking, so that the percentage in the coke is about the same. It should not be much above 1%. According to the researches of F. Wuest (_Journ. Iron and Steel Inst._, 1906) the sulphur is retained in a complex carbon compound which is not destroyed until the coke is actually consumed.
The older methods of coking and the earlier forms of retort ovens are described in J. Percy, _Metallurgy_, Jordan, _Album du cours de metallurgie_; Phillips and Bauerman, _Handbook of Metallurgy_, and other text-books. A systematic series of articles on the newer forms will be found in _The Engineer_, vol. 82, pp. 205-303 and vol. 83, pp. 207-231; see also Dürre, _Die neuern Koksöfen_ (Leipzig, 1892); D. A. Louis, "Von Bauer and Brünck Ovens," _Journ. Iron and Steel Inst._, 1904, ii. p. 293; C. L. Bell, "Hüssener Oven," _id._, 1904, i. p. 188; Hurez, "A Comparison of Different Systems of Vertical and Horizontal Flue Ovens," _Bull. soc. industrie minérale_, 1903, p. 777. A well-illustrated description of the Otto system in its American modification was issued by the United Gas & Coke Company of New York, in 1906. (H. B.)