For persons who may not wish to be at the expense of the lucernal, as formerly mounted by Mr. Adams, Mr. Jones has altered the manner of its support; which, as well as the other particulars, and the method of using it, may be understood from the following description.
Plate IX. Fig. 3, is a representation of the instrument as placed up for use. AA, the top of a mahogany chest, about two feet long, thirteen inches and an half high, and eight inches broad, which serves both as a case to contain the instrument, and to support and preserve it steady when in use. A groove is cut in the top of the box, and another in the inside at the bottom, in both of which the base of the instrument is made to slide. When the instrument is placed inside, a long slip of mahogany slides in at the top, to secure the groove, and make the top perfect. Thus the instrument may be most readily slid out of its case, and then into the groove at top for use, and in much less time than by the brass frame and jointed stand adopted by Mr. Adams. Fig. 3 B, is the stage for the objects, with the condensing lens _a_, and concave mirror _b_, the same as in Mr. Adams’s. C, the brass slider case for opake objects, with a rack cut into its lower edge, and which is turned by a pinion. To this pinion is applied an handle, D, with Hooke’s universal joint; this contrivance gives a certain horizontal motion to the objects while viewing. The stage at C is also made to slide vertically, and a lever-rod or handle, E, to apply through the top, to bring the objects to a just height. Hence, by applying the left hand to the handle, E, and the right to the rod D, the adjustment or the changing of the objects, while under exhibition on the large lenses at F, is produced in the most convenient and accurate manner, and the observer has no occasion, for one slider, to shift from his seat or position.
Rack-work might be applied to the vertical motion, but it is not essentially necessary; for when once the center of the slider is observed, there requires very little change from that position for the complete exhibition of the objects. The whole of the stage, with the lense and mirror, is fixed to a brass dove-tailed slider at G, which slides in another brass piece fixed to the wooden slider or base of the instrument. A long brass rod, H, with an adjusting screw at its end, passes through the two brass pillars, K, K, to the stage at _f_, upon which it acts; and according as it is turned to the right or left hand while examining the objects, moves the objects nearer to or farther from the magnifiers screwed on at L, and produces the just distance for rendering the appearance of the objects the most distinct and brilliant upon the glasses at F.