These solid wires have a certain amount of _resistance_ to the passage of the electricity, just as the water-pipe has to the water, and (as it is in the case of the water) the effect of the resistance to the passage of electricity is greater if you pass a larger quantity through than a smaller quantity.
If you wanted to carry a quantity of electricity to a certain distance, and for that purpose used a wire, there would be a certain amount of resistance in that wire to the passage of the current through it; but if you used two or more wires of the same size, or one large wire, the resistance would be very much less and the current would flow more easily.
Suppose that, instead of emptying the water-tank from the roof through the pipe, we had just turned the tank over and let the water all pour out at once down to the ground. That would dispose of the water very quickly and by a short way, would it not? That is very easy to be seen, because there would be _no resistance_ to its passage to the ground.
Well, suppose we had an electric battery giving a certain quantity of current, say five ampères, and we should take a large wire that would offer no resistance to that quantity and put it from one side of the battery to the other, a large current would flow at once and tend to exhaust the battery. This is called a _short circuit_ because there is little or no resistance, and it provides the current with an easy path to escape. Remember this, that _electricity always takes the easiest path_. It will take as many paths as are offered, but the largest quantity will always take the easiest.
As the subject of resistance is one of the most important in electricity, we will give you one more example, because if you can obtain a good understanding of this principle it will help you to comprehend the whole subject more easily in your future studies.
We started by comparison with a tank holding 100 gallons of water, discharging through a half-inch pipe, and showed you that the pounds of pressure would force the quantity of gallons through the pipe. When the tap was first opened the water would spout up very high, but as the water in the tank became lower the pressure would be less, and, consequently, the water would not spout so high.