The TriMet transit system, serving the Portland metropolitan area in Oregon, owns and operates two different rail transit systems: a light rail system known as MAX, and a commuter rail system known as WES. The fleet of 145 MAX electric light rail vehicles (LRVs) includes five different models, designated by TriMet as "Type 1" through "Type 6". All types are used on all of the MAX lines, but the Type 6 carswhich will gradually replace the Type 1 carsare still being delivered and have not yet begun to enter service. The comparatively very small WES fleet includes three different types of diesel commuter rail cars.
Light rail fleet
Notes on capacities: The capacities given are for a single car; a two-car train has double the capacity. The Type 2 cars originally had 72 seats, but eight seats were later removed, to make space for bicycles. All of these capacity figures are based on "normal" loading conditions (defined as 4 standing passengers per square meter by industry standards); under so-called "crush" loading conditions (6-8 standees per m2), all of these cars are capable of carrying many more passengers than stated here.
Type 1
The Type 1 cars were manufactured by a joint venture between Bombardier Corporation and La Brugeoise et Nivelles (BN; Bombardier would later acquire the company) and featured a raised floor with steps at the doors. TriMet had wanted to contract American firm Budd Corporation, but the company backed out at the last minute. TriMet announced it would purchase an additional seven vehicles in August 1983, but a budget shortfall forced the agency to withdraw this proposal the following November. The cars were built, with some modifications for Portland, to a BN design that had previously been usedunder license by Brazilian manufacturer Cobrasma(PT)for 68 rail cars for Rio de Janeiro. The electrical propulsion equipment was supplied by Brown, Boveri & Company. Bombardier built the frames in Quebec, but its factory in Barre, Vermont, manufactured the majority of each car, with 80 percent of the production and assembly taking place in Barre. The first vehicle was completed at the factory in late 1983 and arrived in Portland in 1984. The Type 1 cars are the only light rail cars in TriMet's fleet that lack regenerative braking capability.
The Type 1 cars were delivered without air-conditioning, but it was added to all cars during a retrofit in 1997–98. These cars were originally equipped with stop-request bell cords (as are commonly found on American transit buses), which passengers needed to pull to signal the operator that they wanted to get off at the next stop, similar to a typical bus or some streetcars. As ridership increased, the stop request feature was relegated to certain lighter used stations during periods of lighter traffic. Finally, in 1994, the bell cords after TriMet adopted an operating practice of having MAX trains stop at every station at all times. The bodies of the Type 1 vehicles include cutaway areas by each truck, for maintenance access. In 1995, TriMet began installing wheel skirts to cover these, to reduce noise, and said that these would be included on all LRVs purchased in the future.
For their first 30 years (until 2016) the Type 1 cars had roll-type, printed destination signs. The Type 1 cars were the only MAX cars whose rollsigns were hand-cranked. Because of the time-consuming process to change the signs, only the sign on the exposed end of the car in a two-car train was changed to the correct destination. The side signs only listed the designated route color (such as "Blue Line") rather than a destination, and the sign on the coupled end of each car in a two-car train was left blank. A two-year program that began in October 2014 and was completed in September 2016 gradually replaced all of the rollsigns in the Type 1 cars (as well as those in the Types 2 and 3) with digital, LED-type destination signs.