It is a disputable question whether such a boat should be a lifeboat. The air-tight compartments, usually made of copper, certainly add to her weight, and, some say, make her less stiff. On the other hand, it is pleasant to feel that your boat is unsinkable, and that if you knock a hole through her bottom with a rock, or ship an unlucky sea, she will not go down. But if you decide, as I should do, on a lifeboat, be sure that she really is one, and that her air-tight compartments are large enough to float her with ballast and crew on board. A 25-ft. cutter, such as is built by White of Cowes, will carry more than half a ton of ballast and half a dozen people quite comfortably when she is full of water. But I have seen small steam-launches, nominally lifeboats, that would undoubtedly, with their engines and boilers on board, sink like stones if they were filled with water.
Wooden air-tight compartments are lighter than copper tanks, but they are apt to warp and become leaky. Twenty-two years ago, in New Zealand, I had a lifeboat sailing-cutter sent out to me by long sea that I had had built for me in England. As soon as she arrived I took a friend out for a sail on a rough day and filled her with water, just to show him her marvellous properties. The result was ignominious. The water-tight (!) compartments filled, and we drifted helplessly home, thanking the Fates that we had nothing but water ballast on board.
The shape of the stern is another point on which opinions may reasonably differ. There is much to be said in favour of a boat being sharp at both ends. A sharp stern is undoubtedly safer when running through broken water or before a heavy sea, and when a boat 'squats' in running before a strong wind it does not drag dead water behind it, and makes a cleaner wake. But unless increased length can be given to the boat it diminishes stiffness. The square-sterned boat carries her bearings farther aft, and so, if both are of the same length, the square-sterned boat, other things being equal, will be the stiffest of the two. But if you decide for a square stern let the boat have a fine run aft, and let the square surface of the stern be small and well up out of the water.