The Canadian Environmental Assessment Act, 2012 (CEAA 2012) (the Act) and its regulations established the legislative basis for the federal practice of environmental assessment in most regions of Canada from 2012 to 2019. It was repealed with the coming into force of the Impact Assessment Act on August 28, 2019.

History

The Canadian Environmental Assessment Act, S.C. 1992, c. 37 (CEAA) is an Act of Parliament that was passed by the Government of Canada in 1992. The Act requires federal departments, including Environment Canada, agencies, and Crown corporations to conduct environmental assessments for proposed projects where the federal government is the proponent or where the project involves federal funding, permits, or licensing. The purposes of the Act were set out as follows: (1) to achieve sustainable development that conserves environmental quality by integrating environmental factors into planning and decision-making process, (2) exercise leadership within Canada and internationally, and (3) to provide access to information and to facilitating public participation.

Canadian Environmental Assessment Act, 2012

The original version of the Act was repealed in 2012 and re-written by the Harper government. The new law came into effect on July 6, 2012.

Canadian Environmental Assessment Act, 2012

There are marked differences between the new act, the Environmental Assessment Act, 2012 (sc2012 c-19) and the previous act, the Environmental Assessment Act (sc 1992 c-37). The new Act omits the preamble and statement of purpose. Section 4 of each Act is a clause that lists purposes. The new Act is more restrictive in purpose. It applies to "designated projects" instead of "projects". Public participation is "during" an environmental assessment instead of "throughout". The new Act also adds as a purpose that assessment be completed in a timely manner. The Regulations Designating Physical Activities document (RDPA) describes the projects covered by the new Act. The new Act limits assessment just to the type of projects listed in this regulation (and its amendments).

Canadian Environmental Assessment Act, 2012

The previous Act applied to all projects that altered the environment. The Inclusion List Regulations (SOR/94-637) described projects for which a screening report was always required. The Inclusion List regulation was twice the size of the current list of designated physical activities. The previous Act also required a screening report for any project for which a federal department was required to issue a license or permit under the specific sections of other acts listed in the Federal Authorities Regulation (SOR/96-280). The previous Act also required a modified screening report for projects where the proponent was a Crown Corporation or for projects outside of Canada or where the Government of Canada funded the project.

Under the previous Act, other federal departments were not allowed to issue licenses and permits until any required environmental assessment was complete. Under the new Act, certain other departments, specifically the National Energy Board, may issue licenses and permits without an environmental assessment, may conduct their own assessment, and may cancel existing assessments currently in process.

The Prescribed Information for the Description of a Designated Project Regulations (SOR/2012-148) gives the information required under the new Act. A lawyer with no knowledge of biology could supply the information. Only section 17(a) question, the requirement to describe changes the project may cause to fish habitat requires knowledge of ecology. Information on environmental effects is limited to effects on fish, aquatic species, and migratory birds.

The regulations under the previous Act required essentially the same information in the basic project description, except that it also required information on terrain, air, vegetation, all wildlife, and all habitats.

Central to the previous Act was a comprehensive study. What was to be included in the study was determined for each project. The agency issued a project-specific comprehensive study guideline within 90 days of receipt of the project application. The comprehensive study specified baseline data that needed to be collected, identified specific groups that needed to be consulted, and identified specific concerns for the proponent to address. The new act does not require a comprehensive study.