[Illustration: Fig. 16.--Handling the frame: Third position.]
In placing frames in the hive great care should be exercised that they are properly spaced. Some frames are self-spacing, having projections on the side, so that when placed as close as possible they are the correct distance apart. These are good for beginners or persons who do not judge distances well and are preferred by many professional bee keepers. If unspaced frames are used, the brood frames should be 1-3/8 inches from center to center. A little practice will usually enable anyone to space quickly and accurately. Careful spacing is necessary to prevent the building of combs of irregular thickness and to retard the building of pieces of comb from one frame to another.
A beginner in beekeeping should by all means, if possible, visit some experienced bee keeper to get suggestions in handling bees. More can be learned in a short visit than in a considerably longer time in reading directions, and numerous short cuts which are acquired by experience will well repay the trouble or expense of such a visit. Not all professional bee keepers manipulate in the very best way, but later personal experience will correct any erroneous information. Above all, personal experimentation and a study of bee activity are absolute necessities in the practical handling of bees.
In increasing the apiary it is sometimes best to buy colonies in box hives on account of their smaller cost and to transfer them to hives with movable frames. This should be done as soon as possible, for box hive colonies are of small value as producers. The best time to transfer is in the spring (during fruit bloom in the North) when the amount of honey and the population of the colony are at a minimum.
Transferring should not be delayed until spring merely because that season is best for the work. It may be done at any time during the active season, but, whenever possible, during a honey flow, to prevent robbing. If necessary, it may be done in a tent such as is often used in manipulating colonies. By choosing a time of the day when the largest number of bees are in the field the work will be lessened.
=Plan 1.=--The box hive should be moved a few feet from its stand and in its place should be put a hive with movable frames containing full sheets of foundation. The box hive should be turned upside down and a small, empty box inverted over it. By drumming continuously on the box hive with sticks for a considerable time the bees will be made to desert their combs and go to the upper box, and when most of them are clustered above, the bees may be dumped in front of the entrance of the hive which is to house them. The queen will usually be seen as the bees enter the hive, but, in case she has not left the old combs, more drumming will induce her to do so. It is necessary that the queen be in the hive before this manipulation is finished. The old box hive containing brood may now be placed right side up in a new location and in 21 days all of the worker brood will have emerged and probably some new queens will have been reared. These bees may then be drummed out and united with their former hive mates by vigorously smoking the colony and the drummed bees and allowing the latter to enter the hive through a perforated zinc to keep out the young queens. The comb in the box hive may then be melted up and any honey which it may contain used as the bee keeper sees fit. By this method good straight combs are obtained. If little honey is being gathered, the colony in the hive must be provided with food.