=Ques. For what class of machine are copper brushes especially adapted?=
Ans. For machines furnishing large current at low pressure, as in fig. 328.
=Size of Brushes.=--The number of brush sets depends upon the number of poles of the machine, but there may be several brushes in each set. It is usual, except in the smallest machines, to place at least two brushes exactly similar side by side instead of one broad brush, thus allowing one brush to be removed for trimming or renewal while the machine is running. Moreover, better contact is secured by this sub-division, because a slight elevation in the commutator surface at one point may slightly raise one brush of a set at each revolution without much harm, while with one broad brush, the entire brush would be lifted, causing bad sparking.
=Ques. What determines the number of brushes in each set?=
Ans. It depends upon the current capacity, size of machine, and judgment of the designer.
=Ques. What may be said with respect to the dimensions of the brushes?=
Ans. No general rule can be given for breadth and thickness of brush. The contact face must clearly be wider than the thickness of the insulation between commutator segments, since the period of commutation must last an appreciable interval of time on account of self-induction.
=Ques. What should be the minimum width of the brush contact face?=
Ans. It may be taken as one and one-half times the thickness of the commutator segments.
=Ques. How wide should a carbon brush contact be?=
Ans. The brush should be thick enough to cover two and one-half commutator segments. The thickness should in no case be excessive on account of the loss due to heating, which results from the difference of potential at the forward and rear edge of the brush.
[Illustration: FIG. 339.--Contact angle for the different types of brush. At A is shown a brush with tangential contact, and at B, a so called tangent brush; the latter is properly called an inclined brush. Sheet copper brushes are set tangentially as at A, and gauze brushes inclined as at B. Carbon brushes are placed radially as at C when mounted in box holders, and inclined opposite to the direction of rotation when used with reaction holders.]