'Tis toil's reward that sweetens industry--_Ebenezer Elliot_
In the commercial production of furniture the cabinet-maker has nothing to do with the finishing of his work. This essential part of furniture making is turned over to artisans who are finishers by trade. In a separate part of the factory they attend to the cleaning and filling of the wood and to whatever finish is applied to the work of the joiner. It is hardly necessary to add that the finishing of all kinds of woodwork is quite as important as any other feature in its production; for, however good the lines of design may be and however thoroughly the design may be carried out in the construction of any piece of furniture or other woodwork, it may be and often is spoiled as a work of art in the finishing.
[Illustration: Finishing a Library Table. Plate VI]
But the amateur cabinet-maker should be his own finisher. He should familiarize himself with the various kinds of finish that may be applied to the different woods. He should know the object of filling wood and how it is done. He should understand the processes of fuming, staining, and varnishing so well that he can produce with certainty the results desired.
_First Steps in Finishing._--The first step in finishing woodwork is to clean it up and prepare it for the filler. Too great care cannot be taken in examining all surfaces for slight oversights that have occurred in the joinery work or for blemishes that have been acquired in any part of the process of construction. Light planing, chiselling, or scraping, and perhaps a little sand-papering, always with the grain, may be needed to remove these faults and blemishes. The most serious of these generally result from gluing. All surplus glue should be carefully removed, even to the film that soaks into the surface of the wood. The slightest spot of glue remaining will keep the filler out of the wood and show through any kind of finish.
_Importance of Filling._--As soon as the furniture is thoroughly cleaned, if it is to be finished in the natural color, the grain of the wood must be filled with a light, transparent, semi-liquid substance, known as the filler, which, after standing from five to seven minutes, should be thoroughly rubbed off with a piece of coarse cloth or a handful of shavings. This process, as its name indicates, fills the pores of the wood and protects them against the absorption of moisture and the consequent swelling. But this is by no means its chief purpose. Strictly speaking, filling is the ground-work of all subsequent finishing processes and, for that reason, it may be said to be the most important operation connected with wood finishing. If improperly done, no amount of good work with the varnish brush will remove the fault. In fact, good work is impossible after a bad beginning. Good varnishing or good finishing of any kind requires that, before the final finishing processes begin, the surface should be made perfectly level and smooth, free from all unevenness or roughness or minute openings of any kind that might allow the varnish or other finishing material to penetrate the wood. If the filling has not been so thorough that no part of the subsequent finishing material can be absorbed by the wood, a rough surface will be sure to follow. This may, of course, be rubbed down and re-finished, but never with that perfection of result which is assured by laying a good foundation in correct filling. It may be set down as a fundamental principle of wood finishing that the best result is obtained when the filling or surfacing has been so thoroughly done that the thinnest of finishing coats, few in number, are required to produce the desired result.