Frequently a farmer has occasion to lift posts, and has not time to wait for the construction of an iron-shod lever. Figure 167 shows a very simple, inexpensive contrivance for such cases. A spadeful of earth is taken from each side of the post, and a short, strong chain loosely fastened around the lower end of the post, as far down as it can be placed. A strong lever—a stout rail will answer the purpose—is passed through the chain, as shown in the engraving, until the end of the rail catches firm soil. By lifting at the other end of the lever the post is raised several inches, when both chain and lever are pushed down again for a second hold, which generally brings the post out. The chain is furnished with a stout hook at one end, made to fit the links, so that it can be quickly adjusted to any ordinary post.

[Illustration: Fig. 167.—LIFTING A POST.]

Fences, Gates and Bridges — Part 42

There are places, as crossing over gullies, etc., where unusually long posts are desirable, though not always easy to obtain. In such cases properly spliced posts are almost as durable as entire ones. The engraving of the front and side views, figure 168, shows how the splice may be made to secure strength and durability. The splices should be made with a shoulder at the lower end, and well nailed together, after which one or two bands of hoop-iron may be passed around the splice and securely fastened. The hoop-iron band is one of the most important points in a splice of this kind.

Fences, Gates and Bridges — Part 42

[Illustration: Fig. 168.—SPLICING FENCE POSTS.]

Fences, Gates and Bridges — Part 42

To prevent decay at the center, as well as of all that part of the post placed below ground, by use of wood preserving solutions, the following system is both novel and valuable: It is to have a hole in the center of the post, from the bottom upward, to a point that shall be above the ground when the post is in position. Then bore another hole in the side of the post with a slight inclination downward, making an opening in the center hole, as shown in figure 169. A wooden plug, two or three inches long, should be driven snugly into the hole at the bottom of the post, in order to prevent the escape of any liquid that may be used in the operation. When the posts are set in an upright position, a preservative solution may be introduced into the hole in the side and the centre one filled with it, after which a cork plug of some kind should be inserted in the side hole, to prevent evaporation, as well as to keep out dust and insects. The solutions thus introduced will gradually be absorbed by the surrounding wood, until all parts along the entire length of the central cavity must become completely saturated. When the solutions used have been taken up by the surrounding wood, it will only be necessary to withdraw the cork or plug, and apply more, if it is thought desirable. A common watering pot with a slender spout will be a handy vessel to use in distributing the solutions.