Tracked Hovercraft was an experimental high-speed train developed in the United Kingdom during the 1960s. It combined two British inventions, the hovercraft and linear induction motor, in an effort to produce a train system that would provide inter-city service with lowered capital costs compared to other high-speed solutions. Substantially similar to the French Aérotrain and other hovertrain systems of the 1960s, Tracked Hovercraft suffered a similar fate to these projects when it was cancelled as a part of wide budget cuts in 1973.

History

Genesis at Hovercraft Development

It was noticed early on in the development of the hovercraft that the energy needed to lift a vehicle was directly related to the smoothness of the surface on which it travelled. This was not entirely surprising; the air trapped under the hovercraft will remain there except where it leaks out where the lifting surface contacts the ground — if this interface is smooth, the amount of leaked air will be low. This is the purpose of the skirt found on most hovercraft; it allows the fuselage to be some distance from the ground while keeping the air gap as small as possible.

Tracked Hovercraft

The surprising discovery was that the amount of energy needed to move a given vehicle using hover technology could be lower than the same vehicle on steel wheels, at least at high speeds. Over , conventional trains suffered from a problem known as hunting oscillation that forces the flanges on the sides of the wheels to hit the rail with increasing frequency, dramatically increasing rolling resistance. Although the energy needed to keep a hovercraft in motion also increased with speed, this increase was slower than the sudden (and sometimes catastrophic) increase due to hunting. That implied that for travel above some critical speed, a hovercraft could be more efficient than a wheeled vehicle running on the same route.

Tracked Hovercraft

Better yet, this vehicle would also retain all of the positive qualities of a hovercraft. Small imperfections in the surface would have no effect on the ride quality, and the complexity of the suspension system could be greatly reduced. Additionally, since the load is spread out over the surface of the lifting pads, the pressure on the running surface is greatly reduced — about the pressure of a train wheel, about of the pressure of a rubber tyre on a road. These two properties meant that the running surface could be considerably simpler than the surface needed to support the same vehicle on wheels; hovertrains could be supported on surfaces similar to existing light-duty roadways, instead of the much more complex and expensive railbeds needed to support the weight on two rails. This could greatly reduce infrastructure capital costs.

Tracked Hovercraft

In 1960 several engineers at Christopher Cockerell's Hovercraft Development Ltd. in Hythe, Hampshire, began early studies on the hovertrain concept. At the time, a major problem was selecting a suitable power source. As the hovercraft had no strong contact with a running surface, propulsion was normally provided by an aircraft-like solution, typically a large propeller. This limits the acceleration, as well as the efficiency of the system, a major limitation for a design concept that would compete with aircraft on the same routes.

Introducing the LIM

Through the same period, Eric Laithwaite had been developing the linear induction motor (LIM) at the University of Manchester. By 1961 he had built a small demonstration system consisting of a LIM reaction plate and a four-wheeled cart with a seat on top. In 1962 he started consulting with British Rail (BR) on the idea of using LIMs for high-speed trains. A November 1961 Popular Science article shows his Hovertrain concept using a LIM, the accompanying illustration shows small lift pads like those from the Ford Levapad concept, running on top of conventional rails. After moving to Imperial College London in 1964, Laithwaite was able to devote more time to this work and perfect the first working examples of large LIMs suitable for transport systems.