_How Stain is Applied._--If furniture or any kind of woodwork is to be artificially coloured, staining is the first of the finishing operations to be attended to. The stain should be spread upon well-cleaned surfaces by means of a brush, a cloth, or a sponge, and allowed to stand for a few minutes so that it may penetrate well into the wood. The surfaces should then be carefully wiped off with clean, soft cloths or cotton waste to remove any stain that may not have soaked into the wood, and thus prevent a streaked or painted effect. After the stained surface is thoroughly dry, a filler, coloured to match the stain, should be applied and rubbed well into the pores, as already explained in the section on natural finish. The beginner will need to be cautioned again and again not to rub the filler all off or draw it out of the grain, but to rub it in as much as possible. He will also need to be on his guard against the presence of moisture or grease, which will interfere with good results.
Excellent prepared stains in great variety may be easily obtained of dealers in painters' supplies. They will not always produce the effects claimed for them, but with a little experimenting it is possible to find prepared stains that will give almost any desired result. They are somewhat expensive, however, and the amateur finisher may prefer to develop his own stain. Following are some suggestions along this line:
_Asphaltum and Golden Oak Stain._--A good chocolate brown stain may be produced on almost any light-coloured wood by a very thin varnish made by colouring turpentine with asphaltum and applying with a brush. A considerable quantity of asphaltum should be used, but not enough to make a sticky liquid. This will need to be finished with shellac or finishing varnish. When applied to quartered oak it produces the beautiful effect known as golden oak. It may also be used on white wood to give an imitation of black walnut; and Georgia pine under this stain takes on a very attractive tone without obscuring the natural figure of the wood.
_Mahogany._--A clever imitation of mahogany may be made by staining birch of the right grain with logwood stain. The stain is made by boiling together equal parts of logwood chips and water for about three hours. While the mixture is hot, chloride of tin is added gradually until the right shade of colour is produced. The stain should be allowed to cool before it is applied, and then several coats may be needed to secure the right depth of shade. The filler used should be coloured with burnt umber and sienna. The finish may be a brilliant or a flat varnish, or wax.