The best presses of this type were those devised and patented by Isaac Adams, of Boston, in 1830 and 1836, and by Otis Tufts, also of Boston, in 1834. R. Hoe & Co., of New York, acquired Adams' business in 1858 and continued the manufacture of his presses. Over one thousand in many different sizes were made by this firm, the largest printing a sheet 33 × 46 inches at a working speed of one thousand impressions an hour. The last Adams press was made in 1882, but quite a number are still in use in prominent printing-offices in New York, Boston, and a few other cities, where the results on fine book work are still considered better than from the faster cylinder presses. The mechanical principle employed in the Adams press for exerting a flat, parallel pressure has now been generally adopted for heavy stamping and embossing presses.
To go back to the early part of the nineteenth century, when Koenig found his bed and platen press impracticable, he immediately set to work, assisted by one of his countrymen, Andreas Bauer, a mechanic who had helped him formerly, and in the latter part of 1812, the first flat-bed cylinder press was erected by them in Bensley's office. The cylinder of this press had three impression surfaces with spaces between them, and each covered with a soft blanket. With each forward movement of the type-bed the cylinder made one-third of a revolution and then came to a standstill, while the bed returned to its starting-point. The spaces between the impression surfaces allowed the type-form to pass under the cylinder without touching the blankets. At the end of the cylinder and at equal distances along its circumference were hinged three frisket frames, each fitted with tapes having reel springs at one end. The frisket frame of the uppermost impression surface rested in a vertically inclined position against the high framework of the inking mechanism. The sheet of paper was placed upon the blanket, and the cylinder then turned forward, drawing the frisket frame down with it, while the tapes, kept taut by the reel springs, adjusted themselves to the curvature of the cylinder and held the sheet upon it. After one-third of a revolution, the cylinder came to a stop to let the type-bed return. On the next forward movement of the bed and the next one-third of a revolution of the cylinder, the impression was made, and on the next repetition of these movements, the sheet was taken off by hand, and the cylinder returned to its original position to have another sheet placed on the first frisket. At every complete revolution of the cylinder and three complete reciprocating movements of the bed, three sheets were printed.