=Operating Bells at a Distance.= When it is desired to ring a bell situated at a considerable distance from the push, the resistance of the line becomes objectionable.

On lines of 500 feet, No. 18 copper wire and upwards, the battery necessary would be very large, two small batteries and a relay would prove more satisfactory.

How to Install Electric Bells, Annunciators, and Alarms. — Part 9

In Fig. 15 the circuit of a simple form of relay is given. An adjustable contact screw _C_ is placed where an extension _S_ of the armature _A_ can strike it. This extension is provided with a platinum contact. The connections are as in the figure.

How to Install Electric Bells, Annunciators, and Alarms. — Part 9

When the push _P_ is depressed, the current from the main battery _M_ energizes the electromagnet _E_, and the armature _A_ being attracted, contacts _S_ and _C_ meet. These contacts close the second circuit containing the bell _B_ and the local battery _L_.

How to Install Electric Bells, Annunciators, and Alarms. — Part 9

The relay resembles a second push near the bell, but controlled by current from a distance instead of being depressed by hand. Its advantage consists in it needing but a very weak current to move the armature _A_, which is held back by a light spring, or by gravity.

The relay may then be set near the bell and the wires from the push may be of a very great length. Battery _L_, which actually rings the bell, will thus only have to work through a few feet of wire.

=Reducing Resistance of a Bell.= Sometimes it is desired to reduce the resistance the bell coils offer to the current, the bell then working over a very short line with few cells of battery. Or the bell coils may have been wound with fine wire for large battery voltage and a long line.

The bell coils may be put in multiple, the current then dividing and one-half going through each spool.

Untwist the joint between the spools near the yoke or iron bar to which the spools are attached. Join one of these ends to the wire at the armature end of the _other_ spool and the second untwisted end to the armature end wire of its neighboring spool. Use short pieces of insulated wire for these extra connections.

The current now instead of having to go through one spool and then the other, can branch through both at once.

The resistance to the current of one spool is half the resistance of two, the current through one spool will therefore be twice that through the two spools as at first connected. And as there are two paths for it, each one-half the first resistance, the total will be only one-fourth the resistance of the ordinary series arrangement.