The upper end of the pillar is bored through at right angles to the flat at the bottom (see Fig. 2). Through the top a piece of brass tubing about 5/8 in. long is fixed, generally by soldering; this is the bearing for the crank-shaft. The crank-shaft itself is a piece of steel wire bent to the form required. The fly-wheel is fixed to one end, and prevents the shaft coming out of the bearing, the bend of the arm serving the same purpose at the other end.
The cylinder itself is shown at Fig. 3, and also in Figs. 1 and 2. The piston, piston-rod, and bearing which fits the crank-pin are shown in Fig. 4. It will be evident that the dimensions of this engine are microscopic. The bore of the cylinder is 5/16 in., and the barrel itself is often made of triblet-drawn brass tube. The enlarged part at the bottom is a casting with a flat face, as shown in Fig. 3, on one side. Some makers use a casting for the entire cylinder, but the tube is perhaps the cheaper method of making. A piece of good tube is sufficiently accurate in the bore for use as bought, so that the trouble of boring the cylinder is dispensed with. The base, for the tube to fit in, is bored to the external diameter, and the tube fixed with solder. The lid or cover is fixed only by being snapped on. Its object is only to guide the piston-rod.
A reference to Fig. 3 will show the working of the oscillating valve. The face of the pillar is shown on the right. On this, _a_ is the hole from which the live steam issues, and _b_ is the exhaust hole. These holes are technically called ports. The hole _c_ is bored through the pillar, and takes the trunnion, or pin on which the cylinder oscillates. Fig. 2 shows this trunnion-pin prolonged and having a nut on the end. A spiral spring around the trunnion, between the nut and the pillar, keeps the valve face in close contact with the pillar face. Again, turning to Fig. 3, the holes in the cylinder on the left are:--_c_, into which the trunnion is screwed; and _d_, the steam-way.
When the cylinder is in the position shown in Figs. 1 and 2, the port-hole _d_ (Fig. 3) is over the solid metal between the holes _a_ and _b_. On turning the fly-wheel the crank draws the piston out very slightly and inclines the cylinder sideways, bringing the port _d_ over _a_. The live steam from the boiler at once enters and forces the piston upwards, and on the crank reaching the highest point the cylinder is again vertical and the hole _d_ is mid-way between _a_ and _b_. The momentum of the fly-wheel carrying the crank round brings the hole _d_ opposite _b_, and allows the steam to escape. There is no force to keep the engine going during this part of the time except the momentum of the fly-wheel. When the cylinder again inclines to the opposite side _d_ comes over _a_, and force is again applied under the piston. This will keep the engine going.