=2. Use of the Pull-Through.=--(i) Remove the bolt from the rifle, and in order to insure the gradual compression of the gauze, if used, and of the flannelette, drop the weight through the bore _from breech to muzzle_. The pull-through should be drawn through in one motion, otherwise the spot where the flannelette is allowed to rest while a fresh grip of the cord is being taken will not be properly cleaned. Very great care must be taken not to allow the cord to rub against the muzzle, otherwise a groove, technically known as _cord wear_, will be cut, which in course of time will destroy the accuracy of the rifle.
(ii) =Flannelette.=--Only regulation flannelette is to be used. When cleaning or drying the bore after washing out with water, a piece of dry flannelette large enough to fit the bore tightly (about 4 inches by 2 inches) should be placed in the second loop of the pull-through. For oiling the bore, a slightly smaller piece of oily flannelette, which will fit the bore loosely, should be used. Care must be taken not to use too much oil, as it will be squeezed out of the flannelette at the entrance to the bore, and will run down into the bolt when the rifle is placed in the rack, and may then cause miss-fires.
(iii) =Caution.=--The use of _two single pull-throughs attached to one another_, so as to make a double one, is strictly forbidden, because this practice has been found to produce “cord-worn” barrels.
=3.= (i) =Wire Gauze= (Fig. 1).--Wire gauze in pieces 2½ inches by 1½ inches is supplied, and should be used for the removal of hard fouling or of rust. In attaching it to the pull-through, the following method should be adopted: Turn the shorter sides of the gauze towards the upper, so that the longer sides take the form of the letter S. Open the first loop of the pull-through, and put one side of it in each loop of the S. Then coil each half of the gauze tightly round that portion of the cord over which it is placed till the two rolls thus formed meet. _The gauze must be oiled thoroughly before use to prevent its scratching the bore._
(ii) =Object of Gauze.=--The object of the gauze is mainly to scour out the grooves, and it should therefore fit the bore tightly. When it fails to do this, it should be unrolled partially, and packed with paper or flannelette to increase its bulk.