The number of carriers necessary depends entirely upon the volume of work to be handled. But it is desirable, when possible, to have a sufficient number of carriers to hold all the work until the varnish is sufficiently dry for rubbing. In this way a tremendous amount of labour and time is saved.

Permanent carriers, in which the work has been secured by ordinary screws, have been constructed by some manufacturers at an unusually low cost by their own machinists in their own factories.

Painting by Immersion and by Compressed Air — Part 26

The work in the carriers can be easily dusted by means of air-bellows or a compressed air-blower. Work finished in this manner is so clean that the usual sanding is not necessary and a considerable amount of labour thereby saved.

Painting by Immersion and by Compressed Air — Part 26

That the Standard hydraulic immersion system of automatic finishing of pianos has distinct advantages over the ordinary hand process is obvious even to the casual observer. Among the numerous advantages which have been effected the following seem to be worthy of special consideration:

Painting by Immersion and by Compressed Air — Part 26

It constitutes practically the factory's entire varnishing force.

Its use insures an even coat, free from imperfections.

Coating both sides of the work preserves the cases considerably from shrinking and warping. A great deal of labour is saved by varnishing both sides at once.

It requires very little more varnish than the old, slow, hand method as there is no waste from brushes and pots and absolutely no dripping outside the tank.

The elasticity of the Standard system of piano varnishing eliminates the necessity of additions and reductions to the working force.

The cleanness and evenness of the finish virtually makes every coat a flowing coat. The amount of time and effort saved in the rubbing and polishing is tremendous, and the finish obtained is much finer, due to the absence of uneven coating and the blemishes of pinholing and dust.

Carriers containing six complete pianos each, at an average interval of one half-hour, will enable the factory to turn out 108 pianos with one coating during a nine-hour working day.

Carriers containing eight complete pianos would handle 144 pianos a day. A lift sufficiently strong to accomplish any demand placed upon it can be installed to immerse as many carriers at once as will be necessary.