Some bakers set a sponge with compressed yeast and rye flour and let the sponge drop twice. The sponge is made very slack, and contains two-thirds of the water, and the other third part of the water is put on for the dough. Letting the sponge drop twice gives it a little more acidity to the dough. This process would make a much better flavored bread if the sponge was taken on the first drop, and for doughing three or more pounds of old rye dough added, according to the amount of bread to be made; it would give better flavor and make a moister loaf.
In other bakeries where only a small quantity of rye bread is required, bakers do not set a separate sponge for rye; they dip out of a broken-up wheat sponge and make the dough with rye flour; a piece of sour dough is added by some bakers, which gives better flavor to bread made by this method. The sour dough process consists of a succession of sponges; every day a small piece of sour rye dough is left over for this purpose to begin with. It is important in this process to keep the sour dough from getting too old, because when too old it becomes putrid and loses strength. Where rye bread is not made every day, or where sour dough is kept over from Saturday to Monday, we used to work plenty of rye flour with some salt in the piece of dough kept over, and make a very stiff dough, and rolled this in a well-dusted flour bag and kept in a cold place till required. (In southern Germany the sour dough is kept in a liquid state, it is thinned with cold water and kept in a cold place.) Only a small quantity is required for a start; this is freshened up once or twice before it is made into the first and second sponge, after which the final dough is made. For instance, to make a batch of 100 pounds of rye flour into bread the procedure is as follows: Two pounds of sour dough are freshened up with one quart of water and one pound of rye flour into a soft sponge at about 75 to 80 degrees Fahr. After three hours add two more quarts of water and about six pounds of flour and make this into a medium firm sponge, this is called “grund sour.” In from five to six hours this will be ready for the second sponge or “voll sour.” For this second sponge add fifteen quarts of water and with about forty pounds of flour make a soft sponge. This sponge will be ready in from three to three and one-half hours and drop. For the dough add fifteen quarts of water, about one and one-half pounds of salt and about fifty-two pounds of rye flour and make a smooth stiff dough. After the dough is made it should not be given much time to come on before scaling and moulding, because the large second sponge will cause the dough to ripen quickly during the time it is scaled and moulded. This should be done in as short a time as possible so the first loaves do not get too much proof before the rest is moulded. For a smaller batch more time can be given. This process of getting the sponges ready for the final dough may seem tedious to some readers, but the rye bread is baked generally during the daytime, while breads and rolls are baked at night, the freshening-up and setting first and second sponge is done during the night, this is particularly so where there is only one oven.