Fig. 492 exhibits a fan used in dredging pumps used for all sorts of stuff that will pass through the connecting pipes.

There are two general types of centrifugal pumps, viz., 1, _single suction_, Fig. 493, in which the suction pipe enters the end of case parallel to, and in line with its center; 2, _the double suction_, Fig. 494, in which the suction pipe is divided forming a ^U^ shape and enters the case at both sides of the center.

Pumps and Hydraulics - Part Two — Part 113

The single suction is used for clear water only, while the double suction will pass everything that enters the suction pipe—see engravings.

Pumps and Hydraulics - Part Two — Part 113

When the pump is located above the water, it has to be primed before it will raise water. For these purposes an ejector, or exhauster, is frequently employed, which will exhaust the air and draw water up from the required depth. The arrangement of the ejector is illustrated at A, in Fig. 496, and is the smallest and most convenient contrivance that can be used for this work. It is screwed into the highest part of the pump, and is connected by a separate steam pipe to boiler. In a short time after turning on steam, the pump will be primed, the pump remaining stationary during the operation of priming.

Pumps and Hydraulics - Part Two — Part 113

To prevent air returning through the discharge pipe, a check valve, B, is used. For larger pumps a gate valve is generally employed here.

A foot valve fitted with a strainer to keep out obstructions likely to clog the pump should be used as it keeps the pump primed and ready for immediate use.

The general form of the blades is of great importance in this type of pump, because the water is driven through the fan partly by the pressure of the blades on the water and partly by centrifugal force. The ratio which each of these forces bears to the other varies in the same pump, depending upon the proportion the speed bears to the height of it. With low lifts and high speed the water is discharged with but little rotary motion, the resistance to the outward motion of the water being so small that the oblique action of the blades is sufficient to effect the discharge without imparting to the water the same speed of rotation as is given to the fan. The principal object in this type of pump is to effect the discharge of as large a volume of water as possible with the least rotary motion. The power absorbed in imparting the latter motion is not given up later on and consequently is lost, while the rotary motion tends to impede the flow of water.