The following description will give the reader some idea of ordinary painting. The woodwork having been prepared for fixing, has first to undergo the process of “knotting,” in order to prevent the turpentine in the knots of fir-wood from passing through the several coats of paint. One method for best work is to cut out the knot whilst the work is at the bench to a slight depth, and to fill up the hole with a stiff putty made of white lead, japan, and turpentine. There are many ways of killing the knots: the best and surest is to cover them with gold or silver leaf. Sometimes a lump of fresh slaked lime is laid on for about twenty-four hours, then scraped off, a coating of “size knotting” applied, and if not sufficiently killed, they are coated with red and white lead in linseed oil, and rubbed down when dry. The general method is to cover the parts with size knotting, which is a preparation of red lead, white lead, and whitening, made into a thin paste with size. The most common mode is to paint them with red ochre, which is worth nothing. The next process is that of priming, which consists in giving a coat of white and red lead, and a little dryers in linseed oil. This is the first coat, and upon which the look of the paint on completion depends. This first, or priming coat, is put on before “stopping” the work, should that process be required. It consists in filling up with putty any cracks or other imperfections on the surface of the wood. If the putty used in the process of stopping be introduced before the first coat of colour is laid on, it becomes loose when dry. After this first coat, pumicing is resorted to for removing all irregularities from the surface. It is worth recollecting that _old_ white lead is much superior to new for all painting operations. A smooth surface being thus obtained, the second coat is given, consisting of white lead and oil: about one-fourth part of turpentine is sometimes added for quick work. If four coats are to be laid on, this second one has sometimes a proportion of red lead, amounting to a flesh colour; but if only three, it is generally made to assume the tint of the finishing coat. It should have a good body, and be laid even. This coat, when thoroughly dry and hard, is, in best work, rubbed down with fine sand paper, and then the third coat, or “ground colour,” applied of a somewhat darker tint than wanted when finished, having sufficient oil for easy working, but not too fluid: thus two-thirds oil, and one-third turpentine. The “flatting” coat follows, the object of which is to prevent the gloss or glaze of the oil, and to obtain a flat, dead appearance. White lead is mixed with turpentine, to which a little copal is sometimes added, and when the tint is put in it is always made lighter than the ground colour, or it would, when finished, appear in a series of shades and stripes. Flatting must be executed quickly, and the brush is generally, if not always, carried up the work, and not across it.
Transport Brief
A Treatise on the Origin, Progress, Prevention, and Cure of Dry Rot in Timber — Part 118
Tags