Now punch a small hole in the back of the skull a little above the occipital opening, pass the end of the body wire through it, force the end through into the nasal cavity and on out at the end of the nose. Let the end of the wire also pass through one of the nostrils of the skin for about two inches. Now put some soft clay on the sides of the skull and jaw to replace the muscles which have been cut away, and fill the orbits with the same material. Anoint the skin of the head and neck with the arsenical soap, turn it back over the skull, and when the skull is once more in its proper position in the skin, which can best be determined by noticing whether the eye opening comes over the centre of the orbit, drive a tack over each eye through the skin and into the bone.
Another tack at the top of the head will also do good service in holding the skull in its place while the grand struggle with the body is going on, for the head is the last thing finished. Life is too short and space too valuable to allow me to explain fully why all these things must be done, but if you neglect any of these simple directions you will very soon find out why they were given.
The legs and tail are wired and made, the skull is in its place, with one end of the body wire passing through it, and we are now ready to wire all the parts of the animal together. The skin lies on the clean table before us, right side out, with the legs in the same position as when we drew the outline. Bend the inner ends of the foreleg wires back from the head of the humerus at an obtuse angle, and let them cross each other like the limbs of an X, as seen in the accompanying figure. At the point where they cross each other, turn a little ring in the body wire, six inches from the end, just large enough for the two wires to pass through easily. For this purpose you will find a pair of round-nosed pliers convenient. Pass the end of each foreleg wire through the ring, and let them cross again, with the wire of the left leg underneath the other.
[Illustration: FIG. 26.--Wiring Together.]
Now refer to your outline, measure the distance between the extremities of the toes, and it will tell you exactly how to adjust the leg wires so as to get the right distance between the two ends of the humeri, or, in other words, the shoulders. The wire between the head of the humerus and the ring represents the scapula, and, if rightly measured, will enable us later on to pose the forelegs with ease and success.