To mount a specimen belonging in this section, proceed precisely as directed in the previous chapter, with wiring and making each leg, _except_ where the specimen is so large that it requires rods for the legs instead of wires. It is only the larger and heavier animals of this section, viz., the wolves, large dogs, large kangaroos, anthropoid apes, and the like, that require rods instead of wires. For your foxes, baboons, and small kangaroos, you can use wires of the large sizes, of about the same proportionate length as for your squirrel. In getting out the rods for the legs of your large specimens, use Norway iron, because it is toughest, and proceed as follows:
Decide upon the attitude of your specimen, then lay the bones of each leg in its intended position on the table, take a straight wire of large size (No. 9) and bend it to fit the back of the leg bones, precisely where you wish your rod to go. Leave an end about two and one-half inches long, projecting _straight downward_ from the centre of the foot, to go through the pedestal and receive a nut underneath. Cut a thread on this lower end, and fit a hexagonal nut. For the hind legs, let the upper end of each rod project beyond the upper end of the femur for a distance equal to about two-thirds the length of that bone. The irons to support the head should be two in number, and should be long enough to reach from the end of the nose to the centre of the body. The tail iron will be regulated by circumstances.
THE HAND OF AN ANTHROPOID APE.--It nearly always happens that every skin of a large gorilla, chimpanzee, or orang utan is totally destitute of bones. Now the hand of such an animal is a very important feature. Do not attempt to make it with wires and tow alone, for if you do, the fingers will be semicircles, resembling the half of an over-brown doughnut. Each joint must show _an angle_, and each finger be _flat_ on the inside. The accompanying cut (Fig. 29) shows how to make the hand of an anthropoid ape so that it shall be as natural as life. The wooden bones give the proper angles at the joints, and the tow-wrapped wire underneath gives the finger its proper breadth. When all is ready, cover each finger manikin with clay, _make the palm hollow and flat_, and let the end of the iron rod come out in the centre of the palm. This method gives a hand that is beyond criticism. For hand and foot studies of apes and monkeys, see "The Standard Natural History," vol. v., page 512.