[Illustration: FIG. 29.--Artificial Skeleton for Hand of an Orang Utan.]
The following animals, when of adult size, require leg supports of the following sizes: Large foxes, No. 8 wire; olive baboon, No. 5 or 6; small kangaroo, No. 4 to 6; wolverine, No. 6; coyote, 1/4 inch rod; setter dog, 1/4 inch; peccary, 1/4 inch; great ant-eater, 1/4 inch; gray wolf, 5/16 inch; giant kangaroo, 3/8 inch for hind legs; harp seal, 3/8 inch.
Having made the legs complete, lay the skin upon its back, with the legs spread out, make the irons or wires cross each other as shown in the accompanying figure (Plate VI.), and then hew out a piece of tough wood of the general shape and proportion as that shown in the cut. Let this be as small as practicable to avoid splitting when the irons are stapled down upon it. Round off the corners and the ends, so that you can easily work all around this wooden backbone, when filling the animal. Now lay this piece of wood in the skin, upon the crossed leg irons, mark the points at which the irons need to pass through it, and bore holes accordingly, _slanting_ each hole through the stick, for good reasons. The next step is to pass the irons through these holes (by bending them a little, and straightening them afterward) and when all are through, adjust the legs so that there is plenty of loose skin in the body, both in length and breadth. Remember that the stick is to be in the centre of the body, not the top. When the adjustment is complete, bend the end of each iron sharply down upon the stick, and staple it down with the utmost firmness.
Next pass one of your neck irons through the skull from back to front, boring a hole at the back for the purpose, so as to make the end of the iron pass out at the nasal cavity. Replace the missing flesh of the skull with tow or excelsior, bound down with thread, cover all with clay, poison the inside of the head and neck skin with arsenical soap, insert the skull in the head, and fasten the lower end of each neck iron firmly upon the centre stick.
The tail must now be made, but it is wise to fasten the tail iron so that it can be made to slip out or in, until it is known precisely how long it shall be, and then the end may be fastened securely with staples. Now bend up the legs into position, and give the animal its attitude. Procure your pedestal, or limb of a tree, and place the animal in attitude upon it; mark where the iron supports are to pass through, bore the necessary holes, and see if the animal will stand just as you wish it to. If not, work at its legs, and bore new holes until it does; then take it off, poison the inside of the skin liberally with strong arsenical soap, and proceed to stuff it with straw, or chopped tow, or excelsior if you prefer that, but I never do. For my own use I prefer soft straw, chopped fine.