[Illustration: Fig. 32.--HOOK USED FOR SUSPENDING METAL BOXES WHILE DIPPING.]

Another very important point to be attended to is to exclude all dust, and for this purpose the Crittall Manufacturing Co. have erected in this department screens of wire of the finest mesh over windows, so that no air can pass into the room without the dust being screened off.

Painting by Immersion and by Compressed Air — Part 33

A matter of very great importance, yet one which is frequently overlooked in painting iron and other goods which are to have a glossy finish, either air dried or stoved, is to exclude dust from the apartment in which the work is done. In many engineering shops the nature of the business gives rise to a considerable amount of dust, and if this is allowed to enter the paint shop it will be fatal to the appearance of the painted work, as many specks will inevitably settle on the work and mar its appearance.

Painting by Immersion and by Compressed Air — Part 33

[Illustration: Fig. 33--DIPPING CASEMENTS AT BRAINTREE. NOTE THE NARROW TANK USED FOR THIS CLASS OF WORK.]

Painting by Immersion and by Compressed Air — Part 33

A paint shop is best provided with a concrete floor, and this should be frequently cleaned. The workmen should wear clean overalls, frequently renewed, and even so small a matter as keeping the hair, beard, etc., clean and free from dandruff should be attended to. The doors are best if double, and thick felt may be used with advantage in the joints so as to practically seal the opening when the doors are closed. Air which is admitted, either through ventilators or windows, should be strained before entering the building, and for this purpose silk gauze of the finest mesh is usually employed. In some cases, cotton wool in addition is placed in such a position that the air must pass through it before entering the room. If these precautions are taken it will be found that the quality of the work is greatly enhanced.

It may be observed in this connection that it is important also to provide means of adequate ventilation of the apartment. Moisture charged air has a bad effect upon paint work. Extreme heat is unnecessary, but it is very important that the temperature be maintained at a uniform rate, say 60° F. If the room in which the painting is done is very hot, the paint will be affected and be likely to become too thin for its purpose; while, on the other hand, if the room or articles to be painted are very cold, the paint or enamel will have a tendency to congeal. Both of these defects can be remedied, as already stated, by a good system of ventilation and maintaining the heat, night and day, at a uniform temperature.