It is upon the design of this element that the losses in the meter depend. Current is flowing through the shunt coil continuously, even when no energy is being taken, and the higher the inductance of this coil, the smaller will be the energy component of the constant flow. The series coil causes a loss of energy proportional to the square of the current flowing. It also causes a drop in voltage, both inductive and resistive, hence, the resistance and inductance of the series coil of the meter should be as low as possible.

~Ques. How should the magnetic circuit be designed?~

Hawkins Electrical Guide v. 7 (of 10) — Part 149

Ans. The design should be such that the increase of magnetic flux with high voltage or high current will not have a retarding action but will act only to increase the torque.

Hawkins Electrical Guide v. 7 (of 10) — Part 149

If the retarding effect be not prevented, the meter will, of course, run slow at overloads. A comparative test of meters at varying load and at varying voltage will reveal the characteristics of the magnetic circuit.

Hawkins Electrical Guide v. 7 (of 10) — Part 149

~2. The Moving Element.~--This usually consists of a light metal disc revolving through the air gap in which the rotating field is produced.

[Illustration: FIG. 2,547.--Moving element of Sangamo single phase induction watt hour meter. It consists of a light aluminum disc mounted on a hard brass shaft, the entire system weighing 15.6 grams. The disc is swaged under heavy pressure, to render it stiff. The arrangement of the disc, shaft, and bearings is shown in fig. 2,548. By unscrewing the upper and lower bearings the disc and shaft can be removed without disturbing the magnets or adjustments.]

Ans. It acts like the squirrel cage armature of an induction motor, developing the motive torque for the meter.

~Ques. How is this torque counter balanced?~

Ans. By the retarding element so that the speed is proportional to the torque.

~Ques. How should the disc be made and why?~

Ans. As light as possible to reduce wear on the bearings to a minimum.

[Illustration: FIG. 2,548.--Bearing system of Sangamo ~single phase _induction_ watthour meter~. ~The upper pivot, or bearing~ is made of tempered steel wire and of sufficiently small diameter to be quite flexible in the length between the top of the brass shaft and the guide ring in which it rotates. The guide ring, made of phosphor bronze, has the heavy hole lined and burnished. The upper bearing screw, in which the bronze bushing is carried, is so constructed that a long brass sleeve closely surrounds the upper pivot of the spindle. Any blow against the moving system, caused by accident or short circuit, will slightly deflect the shaft until the steel pivot touches against the side of the shell, thus preventing danger of breaking off or bending the upper pivot. At the same time a cushioning or flexible action between the shaft and the bearing shell is secured, thus eliminating the effect of vibration in the moving system, which would tend to produce rattling. ~The lower bearing~ consists of a cup sapphire jewel, supported in a threaded pillar, the upper end of which is provided with a sleeve so located that it prevents the moving element dropping out during shipment. This protecting sleeve is held friction tight on the shaft and can be removed if it be desired to inspect the jewel.]