(403) When thread is finally produced, by the processes described, in a suitable condition for sale, it is necessary to form it into small reels or bobbins, or into balls, each containing from 100 to 500 yards. The reels on which thread is wound for sale to the consumer are small bobbins in which a short barrel is used, with a head or flange at each end. The flange is bevelled on its inner side, and the length of the opening between the flanges is greater at their peripheries than at their roots. The reels are filled with thread by the action of a machine of great ingenuity called the “spooling machine.” This was originally invented by the late Mr. Wm. Wield, and is now made by his successors, Messrs. Shepherd and Ayrton. A perspective view of it is given in Fig. 214, and, as there shown, it has eight heads. The empty spools are placed in a trough, the mouth of which terminates immediately behind the winding head. The latter consists of two spindles which grip the spool in the centre, being formed conically at their extremities, so that they get a firm grip of the hole in the centre of the barrel. The operative mechanism in this machine is fixed in the double frame, or “headstock,” shown at the right hand of the machine, and drives, by means of longitudinal shafts and wheels, the spindles of the whole of the heads. The thread is guided by steel guides, threaded on their underside to correspond with the pitch of the spirals formed by the thread, upon which during winding they rest. The guide rods, upon which the guides are fixed, receive an oscillatory movement after the reels are filled, so as to leave the space free for the removal and replacement of the spools. In addition to this they have a reciprocal horizontal traverse equal in length to the length of the spool, and gradually increasing as the surface upon which the thread is wound increases, owing to the bevel of the heads of the reels. This reciprocal movement is obtained from the revolution of a finely pitched screw on a roller, with which two half nuts alternately engage, one on each side of its centre. As these are thrown into gear they give a traverse to the guide rail in each direction, and it will be easily understood that the period of their engagement determines the length of the guide traverse. In commencing to wind a set of reels the first operation is to place them between the spindles. One reel falls out of each trough on to a plate, which rises so as to hold the reel or spool between the open spindles. The spindles close upon the spool, which immediately begins to revolve and draw thread from its bobbin, which, with its fellows, is held in a suitable creel. The thread is passed through a spring tension clip, which holds it sufficiently to keep it tight, and afterwards over the guide referred to. Winding goes on until the required definite length is wound on, when it automatically ceases. Immediately this occurs a knife placed in an arm descends and cuts a nick in one end of the spool, and the thread is drawn into this nick. In this way the end is secured, and, as soon as this is effected the thread is drawn over a knife and cut. The spindles then open and the spools fall down a shoot. Another set of spools is then fed, as described, and the ends of the thread are so held that, immediately the spindles begin to revolve, they are drawn on to the spools, winding thus beginning automatically. Owing to the perfect automaticity of the machine a high rate of speed is obtained, and 26 gross of spools, each containing 200 yards of thread, can be produced from a machine in 10-1/2 hours.
Coffee Brief
Modern Cotton Spinning Machinery — Part 193
2026-11-16 12:56:10 · Cedar Herald Index
Tags
WorldBusinessTechnologyScienceHealthCultureTravelSportsPoliticsEnvironmentEducationOpinion