MOUNTING SMALL AND MEDIUM-SIZED FISHES WITH SCALES.--The process of skinning a fish has been described in a previous chapter, and on this subject but few other points remain to be noticed. These are the following:
From some fishes the scales fall off so very easily while they are being skinned and mounted, it is necessary to wipe the specimen dry, and before starting to remove the skin, paste a piece of thin but tough writing-paper over the whole fish excepting the fins, and let it dry before proceeding further. With a pen, line out the course of the opening cut, and make a mark across it here and there to guide you in joining the edges again after mounting. This paper covering will fully protect the scales from displacement, and it is to remain on until the mounting is completed, when its removal is easily accomplished with water and a sponge.
On the great majority of scaled fishes, however, the scales are sufficiently persistent that the above is unnecessary. But keep the fish wet while you are at work upon it, and handle it with care and delicacy. If you let the scales get dry, their edges begin at once to curl up, which must not be permitted.
It is generally of great advantage to allow the skin of a fish to lie over night in spirits (two parts of ninety-five per cent alcohol to one of water) for the sake of curing and toughening the integument, and curing whatever particles of flesh may chance to remain in the skull.
After having removed the skin, it must be cleaned most carefully. With a keen-bladed knife, pare and scrape off all the adherent flesh from the skin, cut out the gills, and remove the flesh from the interior of the skull, and the base of the fins. Of course the eyes must come out also. With a stout pair of scissors trim off the projecting bases of the rays of the dorsal and anal fins, so that the fin itself may set squarely upon the top of the centre-board.
I will now describe, step by step, the entire process of mounting a fish by what I consider the simplest, easiest, and most practical method known. Be advised in the beginning, however, that you can not mount fishes on nice brass standards with nothing at all in the way of special materials and tools. You must have an assortment of hard brass wire, Nos. 3 to 10, a hack-saw, some brass rosettes, a small die for cutting threads on brass wire, and taps of corresponding sizes for cutting threads in the brass nuts and rosettes. The outfit is by no means expensive, but it is indispensable if you wish to mount your specimens on standards, and thus have them show off to the finest advantage.