Another very simple toy to make of this material is a little chicken coop. This is made of one square piece of wood and another piece which is almost square. The first piece (Fig. 3) measures seven inches each way, and the other one (Fig. 4) measures seven inches in one direction, and in the other direction seven inches less the thickness of the wood. This is because one piece laps over the end of the other, and the end of the first piece forms part of the other side of the coop. When these pieces are cut and made perfectly square and true, lap the longer piece over the end of the shorter so that it will be just even with the surface, and nail in position. For the slats (Fig. 5) cut some strips an inch wide and thinner than the sides of the coop. Lath is good if you have it. Two of these strips are ten inches long, two are seven inches, and two are four inches. The longest ones are nailed across the open sides of the coop, one on each side, an inch above the bottom. The middle-sized ones are nailed two inches above these, and the shortest ones two inches higher. Then the ends of these strips are sawed off almost even with the coop.
A little table may be made from one block of wood six inches square, and four cylinders three and a half inches long. For the table top (Fig. 6) select a piece of wood about an inch thick. Make this true, and smooth the top with sandpaper. Then mark on the under side a square which is four inches on a side, and exactly an inch away from each side of the table top. At the corner of this inside square are to be made the holes for the table legs. For these holes you will have to use a bit and brace, and make the holes one inch in diameter and a half inch deep. If you haven’t a bit and brace, you can, with a little more trouble, whittle out the holes. For the table legs (Fig. 7) take four pieces of wood one inch square and three and one-half inches long. By whittling off each long corner edge you can make these from square prisms into octagonal, or eight-sided prisms. Then keep shaving off these corner-edges until the prisms are so many-sided that they are practically round. Smooth them with sandpaper, and glue in place in the holes in the under side of the table top.