Second row, each spoke is passed in front of the next spoke and in back of the next where the end is cut off.

The sides are now woven. A 4-rod coil No. 4 reed holds the glass firmly in place. Follow this with seven rows double weaving No. 2 brown reed and one row No. 4 reed in 4-rod coil. Complete the tray with the plaited border.

Practical Basketry — Part 34

After the tray is finished, singe it to get rid of all the loose bits of reed——then polish the board with two or three coats of wax. The cretonne, reed and stain should harmonize in color. A soft brush produces best results in polishing the basket.

Practical Basketry — Part 34

Board 20 inches by 14 inches. Glass 19 inches by 13 inches. Cretonne 19 inches by 13 inches. 52 spokes No. 5 brown reed, 20 inches. Weavers No. 4 reed.

Practical Basketry — Part 34

The holes should be made about one inch apart. Insert the 52 spokes and make foundation stand as described under preceding model. Be careful that the board is perfectly dry before placing the cretonne upon it. Keep the spokes moist by using a wet sponge; be careful not to allow any water to get under the glass while weaving. Best results are obtained by staining the board first and then weaving a dyed reed; good results, however, may be obtained by making the tray in natural reed first and then staining the board and reed. Great care must be exercised in painting the tray after it is made.

The sides of the oval tray are woven two inches high. First weave one row of 4-rod coil then seven rows of double weaving in pairing. One row of 4-rod coil and the plaited border completes the tray. Polish as described under preceding model.

Diameter of board 10 inches. Diameter of glass 9-1/4 inches. Diameter of cretonne 9-1/4 inches. 39 spokes No. 4 reed, 20 inches. Weavers No. 4 reed.

Prepare the board by making 39 holes 5/8 of an inch from edge of board, 3/4 inch spacing between each hole. Insert the 39 spokes. Weave an under base stand in the following manner: First row, each spoke is brought back of next spoke to right and out in front. Second row, each spoke is passed in front of next spoke to right and in back of second spoke where it is cut off.

This base weaving should be uniform throughout so that the tray base may be perfectly even. Stand the tray on a flat desk and see that each spoke touches the desk. For the side of the tray weave one row of 4-rod wale and finish the ends in the usual way.