The process of manufacturing the best qualities of optical glass may be briefly described as consisting in obtaining a crucible full of the purest and most homogeneous glass, and then allowing it to cool slowly and to solidify _in situ_. From the resulting mass of glass the best pieces are picked and moulded into the desired shape for optical use. It will be seen at once that in this process there is an essential difference from all others that have been described in this book--viz., that the glass is never removed from the melting-pot while molten, and that none of the operations of gathering, pouring, rolling, pressing, or blowing are applied to it. The reason for this apparently irrational mode of procedure lies in the fact that the perfect homogeneity essential for optical purposes can only be attained by laborious means, and can then only be retained if the glass is left to solidify undisturbed; any movement by the introduction of pipes or ladles would result in the contamination of the glass by striæ and other objectionable defects.

The choice and proportion of raw materials used in the production of any given quality of optical glass is governed by the chemical composition which experiment has shown to be necessary to yield the desired optical properties. The composition of optical glass mixtures cannot therefore be varied to suit the conditions of the furnace or to facilitate ready melting and fining, so that many of the usual resources of the glass-maker cease to be available in the very case where their aid would be most welcome to facilitate the production of technically perfect glass. On the other hand, the manufacturer has a certain amount of choice as to the precise form in which the various chemical ingredients are to be introduced into the mixture, and he makes his choice among oxides, carbonates, nitrates, and hydrates, according to the behaviour that it is desired to impart to the mass during the earlier stages of fusion. The state of purity in which the various substances are commercially obtainable also enters largely into the question, since the greatest possible degree of purity in the raw materials is essential to the production of glass of good colour, or rather freedom from colour.

Glass Manufacture — Part 119