When the plaster is hard, which will be in a very short time, pull away your clay wall, and take out the apple and half plaster mould together, lifting the apple from its half clay mould.

Remove the clay from your board and set the plaster mould containing the apple in the centre. Rub lard over the apple and upper edge of the mould, build around it the clay wall, as you did the first time; roll a small piece of clay into a slender conical shape and stand it upright on top of the apple, as in Fig. 169. This will make a hole through which to pour the plaster when filling the completed mould, and it must stand high enough to reach above the top of the clay wall.

The American Girl's Handy Book — Part 120

Pour the plaster over the apple as at first, and let it set or harden. Take away the wall of clay once more, and carefully separate the two parts of the mould with the blade of a table-knife; remove the apple, and all is ready for the final cast which is to produce your plaster fruit (Fig. 170).

The American Girl's Handy Book — Part 120

Thoroughly grease the inside of your mould, fit the two parts together, and wrap and tie them with string to hold them in place.

The American Girl's Handy Book — Part 120

Pour in the plaster, through the hole left in one-half of the mould, until it is quite full; then gently shake it to send the plaster into all small crevices.

Let your mould stand without moving again until sufficient time has elapsed for the plaster to harden; then gently separate the two parts and you will find a perfect cast of the apple.

The ridge made by the joining of the mould you must scrape off with a sharp knife, or rub with sand-paper.

In taking casts of almost any object not too complicated, this same method must be employed. The only difficulty lies in deciding just where to place the dividing-line, which must be exactly at the broadest part of your model, otherwise you will break your mould in taking the object out.

In casting a hand the clay must be built up around each finger to precisely its widest part; therefore it is a good plan, before commencing, to mark on the hand, with a fine paint-brush and ink, the line that is to be observed.

When making casts of long objects, or those that are larger at one end than the other, such as vases, always lay them on one side, as a much better mould can be obtained in that way.