UHF CB-Cedar Herald Index

UHF CB is a class-licensed citizen's band radio service authorised by the governments of Australia, New Zealand, Vanuatu, and Malaysia in the UHF 477 MHz band. UHF CB provides 77 channels, including 32 channels (16 output, 16 input) allocated to repeater stations. It is similar in concept to the General Mobile Radio Service in the United States.

Equipment

User equipment designs are similar to commercial land mobile two-way radio, except the maximum legal output power is 5 Watts. External antennas are permitted and commercially manufactured antennas have gains as high as 12 dB. Handheld transceivers (handy talkies) are permitted and have transmit power from 500 mW to 5 W (full legal power) and are relatively cheap compared to full-sized transceivers. Operation in the band is restricted to modes F3E and G3E (FM or PM of analogue voice telephony) except for channels 22 and 23, which are data modes only.

UHF CB

Licensing

Class licensing means that users do not have to apply for a licence or pay a licence fee; however, they must comply with the regulations of the class licence.

UHF CB

It is illegal to use non-standard radios purchased from overseas because they interfere with licensed land-mobile services. This includes overseas personal radio service devices because they do not share the same band plan, power output and channels as UHF CB. Care must be taken when importing radios from overseas to ensure they comply with local regulations. Approved radios are identified by an Australian standards "C Tick", usually found on the tag or sticker of the radio.

UHF CB

Scan

Many UHF CB radios allow the user to scan channels to find a conversation. Several different scan modes may be provided:

Open Scan scans all 80 channels to find an active conversation. Some radios allow skipping selected channels when scanning.

Group Scan scans a small number of selected channels. For example, a caravanner travelling around the country may choose to group scan Channel 40 (Road Channel), 18 (Caravan Channel) and 5 (Emergency Channel) so they will hear any conversations relating to their travels.

Priority Scan allows selection of a "priority" channel whilst scanning a handful of selected channels. This could be useful, for example, in a convoy of vehicles: convoy members can set their chosen convoy channel as a "priority" whilst scanning the designated road channel for traffic updates etc. If a convoy member speaks, the radio will switch back to the priority channel even if someone is speaking on another channel.

Selcall

Selective calling (Selcall) allows a radio to call another radio using a sequence of tones, usually presented to the user as a series of 5 numbers. UHF CB radios can be set to be completely silent until they receive a series of tones matching a pre-programmed sequence. Radios which have this feature usually indicate that a call has been received by emitting a number of beeps and by opening the squelch. The popularity of selcall has dropped since the introduction of CTCSS.

CTCSS

Continuous tone coded squelch system (CTCSS) allows a group of radios set with the same tone to converse on a channel without hearing other radios using that channel. CTCSS can be used to silence a radio until another radio with the same tone transmits. This allows monitoring of a channel for transmissions from radios set with the same tone without hearing other conversations that use different or even no tone.

The use of CTCSS is not permitted on UHF CB repeaters or the designated emergency channels.

Repeaters

Repeaters extend the range of transmission by receiving and automatically rebroadcasting a transmission using an antenna located in a high location, normally the top of a mountain, tall building or radio tower. Sometimes a transmission range of over 100 kilometres (60 miles) can be achieved through the use of a repeater. Repeaters are on channels 1–8 and 41–48 and the duplex button should be pressed to access the repeater.

Signage

It is common practice to install signs at worksites, roadworks, regional highways, national parks, heavy vehicle checking stations, and on the rear of camper vans and caravans to advertise a UHF channel for communications. For example, during the widening of the M1 Pacific Motorway between Sydney and Newcastle, contractors installed "UHF 29" signs at the entry point of each worksite.