Just as the thinning in polewoods arose from the need of earlier utilization, so the weeding of young growths was done for the purpose of getting material for withes to bind the grain, etc.

The removal of coppice shoots in oak plantings was practiced in Prussia in 1719, and the thinning of too dense sowings was advised by Carlowitz in 1713. Yet much later, even such an intelligent man as Oettelt inveighed against the weeding out of the birch in spruce sowings because “nature prefers variety, with which preference it is not good to interfere.”

A Brief History of Forestry. — Part 46

This was in opposition to v. Langen (1745), who prescribed for the first time regular cleaning or weeding, especially the removal of the softwoods, aspen and birch, and of coppice shoots from seedling forest. It was also known that this weeding is best done “in the full sap,” in order to kill the stocks.

A Brief History of Forestry. — Part 46

8. _Methods of Regulating Forest Management._

A Brief History of Forestry. — Part 46

Organized forest management was slower to develop than silvicultural methods. The first attempts to bring order into the progress of fellings took the form of dividing the whole area into a certain number of felling areas (12, 16, 20, 30, etc.), several ordinances dating from the middle of the 15th and 17th centuries containing prescriptions to that effect.

It is doubtful whether the numbers of these areas indicate years of rotation, in which case they could only have applied to coppice, or whether they indicate periods of return in selection forest, although the historians seem to jump to the former conclusion. The area division practiced by v. Langen in the Harz mountains (1745), who prescribed the division of larger districts into fifty to sixty, of smaller districts into twenty to thirty felling areas, also leaves it doubtful, whether the areas corresponded to an assumed rotation or to a period of return.

At first, the division was not into equal areas, for no survey existed, and its object was simply to localize the cutting and provide orderly progress. The subdivision was made in the mountain country by following the topography, valleys and ridges, while in the plain the lines opened up for purposes of the chase (to set up nets), called _Schneisen_ or _Gestelle_ (rides), bounding square areas called _Jagen_, _Quadrat_, _Stallung_, were used for the limitation of the felling areas. Most commonly, however, largely due to absence of surveys, the ordered division did not materialize, but existed only on paper.