EXPENSE IN CONSTRUCTING CHANGEABLE HIVES.
It is as much work to construct each separate section, as a common hive; consequently, it is three times the expense to begin with. It is objectionable for wintering bees, on the same principle as the dividing hive. I object to it on another point: our surplus honey will never be pure, as each section must be used for breeding, and every cell so used, will contain cocoons corresponding to the number of bees raised.
Also pollen, or bee-bread, is always stored in the vicinity of the young brood; some of this will remain mixed with the honey, to please the palate with its _exquisite flavor_. The majority will probably prefer all surplus honey stored in pure comb, where it will be with proper management.
I will here give a full description of a hive on this principle, as I have the description from one of its advocates, in the Dollar Newspaper, Philadelphia: called Cutting's Patent Changeable Hive.
DESCRIPTION OF CUTTING'S CHANGEABLE HIVE.
"The size of the changeable hive most used in this section, has an outside shell, made of inch boards, about two feet high and sixteen and a half inches square, with a door hung in the rear. On the inside are three boxes or drawers, which will hold about one thousand cubic inches each, and when filled with honey, usually weigh about thirty-five pounds, which is a sufficient amount of honey to winter a large swarm. The sides of these drawers are made of boards, about half an inch thick; the tops and bottoms of the lower drawers and ends of the upper drawers should be three-fourths of an inch, and the drawers should be fourteen inches high, fourteen inches from front to rear, and six and three-fourths inches wide. Two of these drawers stand side by side, with the third placed flatwise upon the two, with a free communication from one drawer to another, by means of thirty three-fourth inch holes on the side of each drawer, and twenty-four in the bottom of the upper drawer, and holes in the top and bottom of the lower drawers, to correspond, and slides to cut off the communication when occasion may require. Thus we see our hive may be one hive, with communication sufficiently free throughout, or we may have three hives combined. The drawers have tubes made in them, (for the bees to pass and repass), which are made to go through the front side of the hive. The back-side of the drawers are doors, with glass set in them. These drawers set up from the bottom of the hive, and rest on pieces of wood, closely fitted in such a way, as to make a space under the drawers for the _dirt_, _dead bees_, and _water_, which collect in the bottom of hives in winter; between the drawers and the outside is an air space of about one-third of an inch.