The plate can be developed in the usual way. Try it and see the results.--_Reported in the Beacon._
[Footnote 1: A communication to the North London Photographic Society.]
Platinotype, which may be considered to be the most artistic of photographic printing processes, may be separated into its three modifications--the hot bath and cold bath, in which a faintly visible image is developed, and the Pizzighelli printing-out paper. The hot bath process, again, may be divided into the black and white and sepia papers. I intend to give you a rough outline of the preparation of the paper and working of these modifications, concluding by demonstrating the hot bath method, and handing around prints by it.
Platinotype may almost be styled an iron printing process, for, while no trace of iron or its salts is found in the finished print, certain salts of iron are mixed with the platinum salt, which is platinum combined with two atoms of chlorine (PtCl2), as a means for readily reducing it; this, however, cannot be effected without the presence of neutral oxalate of potash, hence the use of the oxalate bath. There is no platinum in the paper for the cold bath process, it being coated with ferric oxalate mixed with a very small quantity of chloride of mercury--somewhere about one grain to an ounce of ferric oxalate solution. When dry it is ready for exposure, which is about three times less than with silver printing.
It is absolutely necessary to store all papers for platinum printing in an air-tight tin containing chloride of calcium, which must be dried by heating from time to time. For the cold bath, however, it is important to have moisture present during printing, or it may be after printing and before development. If the paper is left in a dampish room for fifteen minutes, it should be sufficient. Prints made by exposing damp paper, or damping dry paper just before development, must be developed within one hour if the maximum of vigor is desired; by delaying the development some hours, the prints in the meantime being stored in a drawer so that they may retain their moisture, an increase of half tone and warmth of color will be obtained. If it should be necessary to delay development for a day or two, the prints must be dried before a fire soon after being removed from the frames, and then stored in a calcium tube until wanted for development.