The term subcooling (also called undercooling) refers to a liquid existing at a temperature below its normal boiling point. For example, water boils at 373 K; at room temperature (293 K) liquid water is termed "subcooled". A subcooled liquid is the convenient state in which, say, refrigerants may undergo the remaining stages of a refrigeration cycle. Normally, a refrigeration system has a subcooling stage, allowing technicians to be certain that the quality, in which the refrigerant reaches the next step on the cycle, is the desired one. Subcooling may take place in heat exchangers and outside them. Being both similar and inverse processes, subcooling and superheating are important to determine stability and well-functioning of a refrigeration system.
Applications
Expansion valve operation and compressor safety
Subcooling is normally used so that when the refrigerant reaches the thermostatic expansion valve, all of it is in its liquid form, thus allowing the valve to work properly. If gas reaches the expansion valve a series of unwanted phenomena may occur. These may end up leading to behaviors similar to those observed with the flash-gas phenomena: problems in oil regulation throughout the cycle; excessive and unnecessary misuse of power and waste of electricity; malfunction and deterioration of several components in the installation; irregular performance of the overall systems, and in an unwatched situation, ruined equipment.
Another important and common application of subcooling is its indirect use on the superheating process. Superheating is analogous to subcooling in an operative way, and both processes can be coupled using an internal heat exchanger. Subcooling here serves itself from the superheating and vice versa, allowing heat to flow from the refrigerant at a higher pressure (liquid), to the one with lower pressure (gas). This creates an energetic equivalence between the subcooling and the superheating phenomena when there is no energy loss. Normally, the fluid that is being subcooled is hotter than the refrigerant that is being superheated, allowing an energy flux in the needed direction. Superheating is critical for the operation of compressors because a system lacking it may provide the compressor with a liquid gas mixture, situation that generally leads to the destruction of the gas compressor because liquid is uncompressible. This makes subcooling an easy and widespread source of heat for the superheating process.
System optimization and energy saving
Allowing the subcooling process to occur outside the condenser (as with an internal heat exchanger) is a method of using all of the condensing device's heat exchanging capacity. A huge portion of refrigeration systems use part of the condenser for subcooling which, though very effective and simple, may be considered a diminishing factor in the nominal condensing capacity. A similar situation may be found with superheating taking place in the evaporator, thus an internal heat exchanger is a good and relatively cheap solution for the maximization of heat exchanging capacity.
Another widespread application of subcooling is boosting and economising. Inversely to superheating, subcooling, or the amount of heat withdrawn from the liquid refrigerant on the subcooling process, manifests itself as an increase on the refrigeration capacity of the system. This means that any extra heat removal after the condensation (subcooling) allows a higher ratio of heat absorption on further stages of the cycle. Superheating has exactly the inverse effect. An internal heat exchanger alone is not able to increase the capacity of the system because the boosting effect of subcooling is dimmed by the superheating, making the net capacity gain equal to zero. Some systems are able to move refrigerant and/or to remove heat using less energy because they do so on high pressure fluids that later cool or subcool lower pressure (which are more difficult to cool) fluids.
In spaceflight
In spaceflight applications, the term refers to cryogenic fuels or oxidizers which are cooled well below their boiling point (but not below the melting point). This results in a higher fuel density, and hence a higher capacity of the fuel tanks without increasing their weight. At the same time vaporization losses are reduced.
SpaceX's Falcon 9 rocket uses subcooling for its oxidizer. The term superchilling is also used for this technique.