We must fasten on a piece of tape by which to hang the mirror, by pasting down the ends of the tape on the frame (letter T, Fig. 326), and pasting over each a strip of the hardware paper (letter U, Fig. 326). When the frame is quite dry we will paint a branch of dog-wood or some light-colored flower across it, and have as pretty a little mirror as anyone could wish for.

which you can make yourselves by following these directions:

The American Girl's Handy Book — Part 185

The three cheese-box lids will answer nicely as shelves for a work- or bric-à-brac table, and the broomsticks, which are all the same length, will do for the legs.

The American Girl's Handy Book — Part 185

[Illustration: Fig. 327.—Narrow Grooves Cut around Broomstick for Table-leg.]

The American Girl's Handy Book — Part 185

[Illustration: Fig. 328.—Holes Bored in a Box-lid Used as a Table-shelf.]

[Illustration: Fig. 329.—Manner of Fastening a Shelf to Table-leg.]

[Illustration: Fig. 330.—Table-shelf and Leg Fastened securely together by Wire.]

Upon each broomstick mark the distances for placing the shelves, allowing six inches from each end of the stick for the top and bottom, and the exact centre between these points for the middle shelf. With a pocket-knife cut narrow grooves around each stick, one-half inch on either side of the points marked on them (Fig. 327). This will make six grooves on each stick. Now measure the box-lids to find their circumferences, and divide them into thirds, marking the distances on the rim to obtain the true position for the legs. At these points bore four holes with a gimlet, one inch apart, two above and two below (Fig. 328). Through one of the top holes pass a piece of pliable wire, place one of the broomsticks against the rim of the lid, pass the wire back through the other upper hole (Fig. 329), fit it into the upper groove of the stick, and draw it tight. Twice the wire must be put through the upper holes and around the stick in the top groove; then, bringing it down on the inside of the lid, you must put it twice through the lower holes and around the stick in the lower groove; then twist the ends and tuck them under the wire on the inside of the lid (Fig. 330). In this way each leg will have to be fastened to each shelf. When the table is all put together paint it black, and, as soon as it is dry, tie a bright ribbon on one of the sticks at the top, and a charming little bric-à-brac table will be the result of your labor.