Some have erred in teaching sculptors to measure the limbs of their figures with threads as if they thought that these limbs were equally round in every part where these threads were wound about them.

Divide the head into 12 degrees, and each degree divide into 12 points, and each point into 12 minutes, and the minutes into minims and the minims into semi minims.

The Notebooks of Leonardo Da Vinci, Volume 2 — Part 8

Sculptured figures which appear in motion, will, in their standing position, actually look as if they were falling forward.

The Notebooks of Leonardo Da Vinci, Volume 2 — Part 8

[Footnote: _figure di rilievo_. Leonardo applies this term exclusively to wholly detached figures, especially to those standing free. This note apparently refers to some particular case, though we have no knowledge of what that may have been. If we suppose it to refer to the first model of the equestrian statue of Francesco Sforza (see the introduction to the notes on Sculpture) this observation may be regarded as one of his arguments for abandoning the first scheme of the Sforza Monument, in which the horse was to be galloping (see page 2). It is also in favour of this theory that the note is written in a manuscript volume already completed in 1492. Leonardo's opinions as to the shortcomings of plastic works when compared with paintings are given under No. 655 and 656.]

The Notebooks of Leonardo Da Vinci, Volume 2 — Part 8

Notes on the casting of the Sforza monument (710-715).

[If you want to make simple casts quickly, make them in a box of river sand wetted with vinegar.]

[When you shall have made the mould upon the horse you must make the thickness of the metal in clay.]

Observe in alloying how many hours are wanted for each hundredweight. [In casting each one keep the furnace and its fire well stopped up.] [Let the inside of all the moulds be wetted with linseed oil or oil of turpentine, and then take a handful of powdered borax and Greek pitch with aqua vitae, and pitch the mould over outside so that being under ground the damp may not [damage it?]

[To manage the large mould make a model of the small mould, make a small room in proportion.]

[Make the vents in the mould while it is on the horse.]

Hold the hoofs in the tongs, and cast them with fish glue. Weigh the parts of the mould and the quantity of metal it will take to fill them, and give so much to the furnace that it may afford to each part its amount of metal; and this you may know by weighing the clay of each part of the mould to which the quantity in the furnace must correspond. And this is done in order that the furnace for the legs when filled may not have to furnish metal from the legs to help out the head, which would be impossible. [Cast at the same casting as the horse the little door]