After each board has been pressed separately the book should be shut, and pressed again with pressing plates on each side of it, and with tins covered with paper placed inside each board. Light pressure should be given to books with tight backs, or the leather may become detached.
If, on removing from the press, the boards will not keep shut, the book should be pressed again with a folded sheet of blotting-paper in each end. The blotting-paper should have the folded edge turned up, and be placed so that this turned-up edge will be in the joint behind the back edge of the board when the book is shut.
A small nipping-press suitable for giving comparatively light pressure, is shown at fig. 89.
Most covering vellum has a sticky surface, that marks if it is handled. This should be washed off with clean water before tooling. The pattern is blinded in through the paper as for leather, excepting that the paper must not be pasted directly to the vellum, but may be held with a band going right round the board or book. It is best to glaire twice, and to lay on a small portion of gold at a time with benzine. As vellum burns very readily, the tools must not be too hot, and some skill is needed to prevent them from slipping on the hard surface.
Vellum must not be polished or varnished.
Inlaying or onlaying is adding a different leather from that of the cover, as decoration. Thus on a red book, a panel or a border, or other portion, may be covered with thin green leather, or only flowers or leaves may be inlaid, while a jewel-like effect may be obtained by dots, leaves, and flowers, tooled over inlays of various colours. Leather for inlaying should be pared very thin. To do this the leather is cut into strips, wetted, and pared on a stone with a knife shaped somewhat as at fig. 60, B. When the thin leather is dry the inlays of the leaves and flowers, &c., may be stamped out with steel punches cut to the shape of the tools; or if only a few inlays are needed, the tools may be impressed on the thin leather, and the inlays cut out with a sharp knife. The edges of the larger inlays should be pared round carefully. For inlaying a panel or other large surface, the leather is pared very thin and evenly with a French knife, and a piece of paper pasted on to the grained side and left to dry. When dry, the shape of the panel, or other space to be inlaid, is marked on it through the paper pattern, and leather and paper cut through to the shape required. The edges must then be carefully pared, and the piece attached with paste, and nipped in the press to make it stick. When the paste is dry, the paper may be damped and washed off. The object of the paper is to prevent the thin leather from stretching when it is pasted.