Miniaturizing components has always been a primary goal in the semiconductor industry because it cuts production cost and lets companies build smaller computers and other devices. Miniaturization, however, has increased dissipated power per unit area and made it a key limiting factor in integrated circuit performance. Temperature increase becomes relevant for relatively small-cross-sections wires, where it may affect normal semiconductor behavior. Besides, since the generation of heat is proportional to the frequency of operation for switching circuits, fast computers have larger heat generation than slow ones, an undesired effect for chips manufacturers. This article summaries physical concepts that describe the generation and conduction of heat in an integrated circuit, and presents numerical methods that model heat transfer from a macroscopic point of view.
Generation and transfer of heat
Fourier's law
At macroscopic level, Fourier's law states a relation between the transmitted heat per unit time per unit area and the gradient of temperature:
Where is the thermal conductivity, [W·m−1 K−1].
Joule heating
Electronic systems work based on current and voltage signals. Current is the flow of charged particles through the material and these particles (electrons or holes), interact with the lattice of the crystal losing its energy which is released in form of heat. Joule Heating is a predominant mechanism for heat generation in integrated circuits and is an undesired effect in most of the cases. For an ohmic material, it has the form:
Where is the current density in [A·m−2], is the specific electric resistivity in [·m] and is the generated heat per unit volume in [W·m−3].
Heat-transfer equation
The governing equation of the physics of the heat transfer problem relates the flux of heat in space, its variation in time and the generation of power by the following expression:
Where is the thermal conductivity, is the density of the medium, is the specific heat, , the thermal diffusivity and is the rate of heat generation per unit volume. Heat diffuses from the source following the above equation and solution in an homogeneous medium follows a Gaussian distribution.
Techniques to solve heat equation
Kirchhoff transformation
To get rid of the temperature dependence of , Kirchhoff transformation can be performed
where and is the heat sink temperature. When applying this transformation, the heat equation becomes:
where is called the diffusivity, which also depends on the temperature. To completely linearize the equation, a second transformation is employed:
yielding the expression:
Simple, direct application of this equation requires approximation. Additional terms arising in the transformed Laplacian are dropped, leaving the Laplacian in its conventional form.
Analytical solutions
Although analytical solutions can only be found for specific and simple cases, they give a good insight to deal with more complex situations. Analytical solutions for regular subsystems can also be combined to provide detailed descriptions of complex structures. In Prof. Batty's work, a Fourier series expansion to the temperature in the Laplace domain is introduced to find the solution to the linearized heat equation.
Example
This procedure can be applied to a simple but nontrivial case: an homogeneous cube die made out of GaAs, L=300 um. The goal is to find the temperature distribution on the top surface. The top surface is discretized into smaller squares with index i=1...N. One of them is considered to be the source.
Taking the Laplace transform to the heat equation:
where
Function is expanded in terms of cosine functions for the and variables and in terms of hyperbolic cosines and sines for variable. Next, by applying adiabatic boundary conditions at the lateral walls and fix temperature at the bottom (heat sink temperature), thermal impedance matrix equation is derived:
Where the index accounts for the power sources, while the index refers to each small area.
For more details about the derivation, please see Prof. Batty's paper,. The below figure shows the steady state temperature distribution of this analytical method for a cubic die, with dimensions 300 um. A constant power source of 0.3W is applied over a central surface of dimension 0.1L x 0.1L. As expected, the distribution decays as it approaches to the boundaries, its maximum is located at the center and almost reaches 400K