On very thin books it is sometimes hardly possible to get any lettering at all on the back. In such cases the lettering is best put on the side.
In the case of some special books that are to have elaborately decorated bindings, and are on that account sufficiently distinct from their neighbours, a certain amount of freedom is permissible with the lettering, and a little mystery is not perhaps out of place. But in most cases books have to be recognised by their titles, and it is of the utmost importance that the lettering should be as clear as possible, and should fully identify the volume.
For lettering half-bindings and other books on which much time cannot be spared, it would take too long to make out a paper, as described for extra bindings, nor is there on such work much occasion for it. For such books the lettering should be written out carefully, the whole panel prepared and glaired in, and the gold laid on. Then with a piece of fine silk or thread lines may be marked across the gold as a guide to the finisher, and the letters worked from the centre outward, as described for making out the paper pattern. Of course this method does not allow of such nice calculation and adjustment as when a paper pattern is made out; but if a general principle of clear lettering is recognised and accepted, very good results may be obtained.
At the end of the book characteristic examples of blind-tooled books are given (pages 321-25). It will be seen that most of the tools form complete designs in themselves. Although the use of detached die-sunk tools was general, there were also simple tools used, which, when combined, made up more or less organic designs, and allowed more freedom to the finisher (see figs. 96 and 97).
Some use may also be made of interlaced strap-work designs, either worked with gouges, or a small fillet. A book bound in oaken boards, with a leather back with knotted decoration, is shown at page 330. I have found that such binding and decoration is more satisfactory in scheme for old books, than most forms of modern binding.
If a design is simple, the cover is marked up with dividers, and the tools impressed direct upon the leather; or, if it is elaborate, a paper pattern is made out, and the tools blinded through the paper, as described for gold tooling. The leather is then damped with water, and the impressions retooled.