The facility with which breech-loaders can be charged is generally trumpeted forth to the world as an advantage of vital importance; but let us carefully examine this point and see if it has not been exaggerated--whether, in fact, a solid gun cannot be charged and discharged as rapidly as a breech-loader.
In the first place, all guns recoil; this necessitates the relaying of the gun after every discharge, in order to obtain accuracy of aim; and if facility of loading is to be obtained at the expense of aim, it can scarcely be called an advantage. Aim consumes more time than loading. A six-pounder may be loaded and fired six times in the first minute; but it would be impossible to do this and re-lay the gun after each shot. Where then is the advantage of firing six shots per minute if you cannot hit six objects? And if breech-loaders could be fired _sixty_ times per minute, what would they avail if aim was wanting? The raising or depressing of the breech of a gun by means of the elevating screw; slewing to the right or left, spunging the gun, and ramming home the powder and shot, all consume time; hence we think that quickness of loading is worthless.
Breech-loading cannon cannot be constructed for bullets of larger diameter than that of the rifle bore, without a ductile bullet be used; for, as is usual in breech-loading small-arms, the bullet rifles itself as it is forced up the grooves. The projectiles for rifled cannon have hitherto been cast with corresponding grooves and lands to fit the internal form of the cannon. A compound shot, composed of iron, and covered externally with ductile metal, has been tried in a few instances; but, unfortunately, the difficulty of combining two metals so dissimilar as iron and lead has been found so great as invariably to end in a failure; therefore no prospect exists of bringing into play this, the best point existing in breech-loading arms.
Lastly, the tendency of all guns to absorb the heat, developed during explosion, puts a limit to all extreme rapidity of fire; even if this was not already limited by the more essential point of taking aim. At Sweaborg it was found necessary to allow an interval of five minutes between each discharge of a mortar, and yet the whole of them burst after an average of 120 shots. Time and ingenuity spent in planning and constructing breech-loading cannon will always end in disappointment and failure. Many are the plans extant, evincing great skill, perseverance, and everything needful in point of mechanical experience, but betraying a total ignorance of the metallurgic science and of practical results from the use of the engine. The study of these points will save money, time, and what is of more value, brain-work, which might be better employed. Striving to produce perfect breech-loading cannon is like striving to square the circle.