Bioclogging or biological clogging is the clogging of pore space in soil by microbial biomass; their body and their byproducts such as extracellular polymeric substance (EPS). The microbial biomass blocks the pathway of water in the pore space, forming a certain thickness of the impermeable layer in the soil, and it reduces the rate of infiltration of water remarkably.

Bioclogging is observed under continuous ponded infiltration at various field conditions such as artificial recharge ponds, percolation trenches, irrigation channels, sewage treatment systems, constructed wetlands, and landfill liners. It also affects groundwater flow in the aquifer, such as ground source heat pumps, permeable reactive barriers, and microbial enhanced oil recovery. In the situation where infiltration of water at an appropriate rate is needed, bioclogging can be problematic and countermeasures such as regular drying of the system are taken. In some cases, bioclogging can be utilized to make an impermeable layer to minimize the rate of infiltration.

Bioclogging

General description

Change in permeability with time

Bioclogging is observed as the decrease in the infiltration rate. A decrease in the infiltration rate under ponded infiltration was observed in the 1940s for studying the infiltration of artificial recharge ponds and the water-spreading on agricultural soils. When soils are continuously submerged, permeability or saturated hydraulic conductivity changes in 3 stages which was explained as follows. Permeability decreases for 10 to 20 days possibly due to physical changes in the structure of the soil. Permeability increases due to dissolving the entrapped air in soil into the percolating water. Permeability decreases for 2 to 4 weeks due to the disintegration of aggregates and biological clogging of soil pores with microbial cells and their synthesized products, slimes, or polysaccharides.

Bioclogging

The 3 stages are not necessarily distinct in every field condition of bioclogging; when the second stage is not clear, permeability just continues to decrease.

Bioclogging

Various types of clogging

The change in permeability with time is observed in various field situations. Depending on the field condition, there are various causes for the change in the hydraulic conductivity, summarized as follows.

Physical causes: Physical clogging by suspended solids or physical changes of soils such as the disintegration of aggregate structure. Dissolving of the entrapped air in soil into the percolating water is a physical cause for the increase in hydraulic conductivity. Chemical causes: Change in the electrolyte concentration or the sodium adsorption ratio in the aqueous phase, which causes dispersion and swelling of clay particles. Biological causes: Usually bioclogging means the first of the following, while bioclogging in a broader sense means all of the following. Bioclogging by microbial cell bodies (such as bacteria, algae and fungus) and their synthesized byproducts such as extracellular polymeric substance (EPS) (also referred to as slime), which form biofilm or microcolony aggregation on soil particles are direct biological causes of the decrease in hydraulic conductivity. Entrapment of gas bubbles such as methane produced by methane-producing microorganisms clog the soil pore and contributes to decreasing hydraulic conductivity. As gas is also microbial byproduct, it can also be considered to be bioclogging. Iron bacteria stimulate ferric oxyhydroxide deposition which may cause clogging of soil pores. This is an indirect biological cause of the decrease in hydraulic conductivity.

Bioclogging is mostly observed in saturated conditions, but bioclogging in the unsaturated conditions is also studied.

Field observation

Under ponded infiltration

Field problem and countermeasure

Bioclogging is observed under continuous ponded infiltration in such places as artificial recharge ponds, and percolation trenches. Reduction of infiltration rate due to bioclogging at the infiltrating surface reduces the efficiency of such systems. To minimize the bioclogging effects, pretreatment of the water to reduce suspended solids, nutrients, and organic carbon might be necessary. Regular drying of the system and physical removal of the clogging layer can also be effective countermeasures. Even if operated cautiously in this way, bioclogging is still likely to occur because of microbiological growth at the infiltrating surface.