In transplanting smaller subjects, such as plants for the flower garden, much less effort is required. The plant must be lifted with as little injury to its rootlets as possible, and carefully set into the hole, the soil being filled in round it, and carefully pressed close by the hand. For moving small plants the garden trowel is a very convenient tool, but we are inclined to give the preference to the hand-fork. For larger masses, such as strong-growing herbaceous plants, a spade or digging-fork will be requisite and the soil may be trodden down with the feet.
When seedlings of vigorous plants have to be "pricked out," a dibble or dibber is the best implement to be used. The ground being prepared and, if necessary, enriched, and the surface made fine and smooth, a hole is made with the dibble deep enough and large enough to receive the roots of the seedling plants without doubling them up, and the hole is filled in by working the soil close to the plant with the point of the dibble. The pricking out of seedlings in pots in the propagating pit is effected in a similar way. The plants, indeed, often require to be removed and set from ½ in. to 1 in. apart before they have become sufficiently developed to admit of being handled with any degree of facility, and for these a pointed stick of convenient size is used as a dibble. In delicate cases, such as seedling gloxinias and begonias, it is best to lift the little seedling on the end of a flattish pointed stick, often cleft at the apex, pressing this into the new soil where the plant is to be placed, and liberating it and closing the earth about it by the aid of a similar stick held in the other hand.
[Illustration: FIG. 26.--Section of Pot showing Crocks.]
_Potting and Repotting._--Garden pots are made with a comparatively large hole in the bottom, and those of the largest size have also holes at the side near the bottom; these openings are to prevent the soil becoming saturated or soured with superabundant water. To prepare the pot for the plant, a broadish piece of potsherd, called a "crock," is placed over the large hole, and if there be side holes they also are covered. The bottom crock is made from a piece of a broken garden pot, and is laid with the convex side upwards; then comes a layer of irregular pieces of crock of various sizes, about 1 in. deep in a 5-in. pot, 2 in. in an 11-in. or 12-in. pot, &c. The mode of crocking a pot is shown in fig. 26. A few of the coarser lumps from the outer edge of the heap of potting soil are spread over the crocks. The same end, that of keeping the finer particles of the soil from mixing with the drainage crocks, may be attained by shaking in a little clean moss. A handful or two of the soil is then put in, and on this the plant with its roots spread out is to be set, a trifle higher than the plant should stand in the pot when finished off; more soil is to be added, and the whole pressed firmly with the fingers, the base of the stem being just below the pot-rim, and the surface being smoothed off so as to slope a little outwards. When finished off, the pots should be watered well, to settle the soil; but they should stand till the water has well drained away, since, if they are moved about while the fresh soil is very wet, there will be a risk of its becoming puddled or too much consolidated. Larger plants do not need quite such delicate treatment, but care should be taken not to handle the roots roughly. The soil for these may be somewhat coarser, and the amount of drainage material more ample. Larger bodies of soil also require to be more thoroughly consolidated before watering; otherwise they would settle down so as to leave an unsightly void at the pot-rim.