There can be no doubt of the superiority of this mode of turning barrels, if due care only be taken with the tool. If it get blunted by any scales or impurities, it is apt to tear pieces out of the barrel, similar to the rings that may be noticed in a slovenly bored barrel, owing to dirt getting on the edges of the bit. In turning a barrel by a common lathe, it is fixed in the same manner as before; about an inch of the surface at the breech and the muzzle is turned to the diameter wanted; the rest is then removed, and half an inch more is turned four or five inches from either end; then another half inch, at another distance of four or five inches, and so on, according to the length; making an allowance each time in the depth of the turning, according to the taper of the barrel. The iron between these cuttings is then filed off by floats the lengthways of the barrel, or more frequently ground off; this is a sure mode of getting the barrels perfectly straight on the outside, and without any of those hollows and shades which may be always discovered in an ill-made barrel. It is astonishing how beautifully many barrels are struck by the float. The mode of turning by the lathe is, however, cheaper, and is now confined to military barrels.
There is a great diversity of opinion as to the proper inclination of a pair of double barrels. It is needless to state the precise distance at which the converging lines drawn from the centre of each barrel, and indicating the inclination of the barrels to each other, should come to a point. If we take the point of convergence of those lines at 2-1/2 yards, it will follow that, at 40 yards, each barrel, were it fixed in a vice, would throw the centre of its charge six inches on the opposite side of the mark fired at; but if the gun be fired from the shoulder, the recoil will invariably cause the gun to swerve outwards, so that at that distance it will never fail to throw the shot in a good direction for the mark or bull’s-eye.
The subject may be understood by the following observations. All tapering substances, when laid together were the taper extended, would come to a point at a certain distance. Gun-barrels are made to taper towards each other, and some more than others. To make them uniform, it requires that they should be reduced or flattened, so that the thick or heavy end should join closer, to allow the point of convergence to be extended to a greater distance. If, then, we take two barrels two feet eight inches long, and having a solid substance of metal at the breech of 3-16ths of an inch each and 1-16th at the muzzle; it requires the difference 4-16ths to be multiplied 45 times (there being that number of lengths in 40 yards) to ascertain what distance the points of the different lines are from each other: which will be eleven 4-16ths of an inch, or five 10-16th inches from the centre or line of sight. If you wish to reduce it from the centre, you have to join the barrels so much nearer at the breech; or should the inclination be too little, the muzzle must be jointed closer. As, however, all guns are now made very heavy at the breech, they very seldom require any closing at the muzzle: though it is customary to do it, and to a great extent; but it is owing to the ignorance of the nature of shooting.