Make a platform as in Fig. 453 to support the cyclist. Make two reservoirs as already described. Cut a piece of cardboard to fit over the top of box and make holes in it, L and M in Fig. 453. Glue the reservoirs under these. Make a cardboard tray to fit under the wheels for the sand to fall in. Another wheel might be added to work the sails of the windmill in the distance. Very fine sand must be used for working these toys, the best is silver sand and it should be kept as dry as possible.
Fig. 457 shows another modification of this toy. B is a box turned upside down and placed in front of that containing the sand-wheel. A is the cardboard background, suitably coloured. The sailor's legs are cut in one piece and glued into a slit in the box. The body is fastened to them at F by a small paper-clip so that it moves very freely. The arm is fastened on at G. A small match stick passes through the hole in the hand and is glued in the hole in circumference of wheel E.
The axle, M N, to which this wheel is glued passes through the cardboard or wooden standard, D, through a hole in the background, A, and through the centre of the sand-wheel. D is fixed to the box. The arm of the crane, C, made of cardboard or three-ply, is glued to D. A hole is made at G and a corresponding hole in A opposite G. Pass a small stick of wood or cane, K, through these holes and glue it in. The crane should be about 1 inch from the background. K keeps the arm of the crane steady. Tie a piece of cotton to the axle of wheel E, pass it over K or over a small pulley wheel revolving on K G; tie to it a thin wire hook to which a paper box or barrel can be fastened.
In the same way a sailor can be made to work a windlass and drag a paper boat up a sloping beach, a man can draw water from a well or turn a barrel organ, or a paper mouse gummed to a cardboard base can be drawn along until it disappears into its hole.
Fig. 458 shows how a clown can be mounted on a cart so that when the cart is drawn along he dances and waves his arms. In toys of this kind, the wheels should be quite half-an-inch in thickness. They are glued on to round axles which turn freely in small screw-eyes or in holes in wooden blocks fastened under the car or cart. If any part of the axle projects beyond the wheel it gets in the way of the wires. The clown is made of cardboard or three-ply, according to design given in Chapter XVI. It is then fastened securely to rod B, and the latter glued into a hole in the middle of the cart. Fairly strong wire is fastened to the wheel by a nail with a broad head so that when the wire is looped round the nail it turns freely on the nail but does not come off. The wire is bent at right angles twice to bring it close to the figure, as shown at A. It must fit accurately into the holes in the figure. Notice that one leg passes on each side of the post.